Getting Started

•Store the operating instructions in a safe place.

After reading the operating instructions, store them in a safe place as they could come in handy in the future.

•Whenever the power operation button is in the STANDBY state, the unit is still connected to AC line voltage.

Please be sure to turn off the power operation button or unplug the cord when you leave home for, say, a vacation.

•Note that the illustrations in these instructions may differ from the actual unit for explanation purposes.

About the remote control unit

In addition to controlling the DRA-397, the attached system remote control unit (RC-1052) can also be used to control the following products:

qDENON component products

wComponent products other than DENON:

• Set using the preset memory function ( page 20).

Inserting the batteries

qRemove the remote control unit’s rear cover.

ENGLISH

Getting Started

Notes on batteries:

• Replace the batteries with new ones if the set does not operate

even when the remote control unit is operated nearby the unit.

(The attached batteries are only for verifying operation.)

• When inserting the batteries, be sure to do so in the proper

direction, following the “<” and “>” marks in the battery

compartment.

• To prevent damage or leakage of battery fluid:

• Do not use a new battery together with an old one.

• Do not use two different types of batteries.

• Do not short-circuit, disassemble, heat or dispose of batteries

in flames.

• If the battery fluid should leak, carefully wipe the fluid off the

inside of the battery compartment and insert new batteries.

Cautions on installation

Note:

For heat dispersal, do not install this unit in a confined space such as a bookcase or similar enclosure.

Note

(RC-1052)

(RC-1056)

w Set two batteries in the battery compartment in the indicated direction.

R6P/AA

R03/AAA

 

Wall

• Remove the batteries from the remote if it will not be in use for

long periods.

• When replacing the batteries, have the new batteries ready and

insert them as quickly as possible.

Operating range of the remote control unit

•Point the remote control unit at the remote sensor when operating it.

•The remote control unit can be used from a distance of approximately 23 feet/7 meters, at a horizontal angle of up to 30° with respect to the sensor.

(RC-1052)

(RC-1056)

ePut the rear cover back on.

 

30°

30°

or

Approx. 23 feet/7 m

(RC-1056)

 

(RC-1052)

NOTE:

•It may be difficult to operate the remote control unit if the remote sensor is exposed to direct sunlight or strong artificial light.

2

ENGLISH