| Started Getting |
|
|
| Operation |
|
|
function | Network |
Application | PC |
| Troubleshooting |
| Specifications |
LCD button | LCD button |
BACK 
NEXT DEVICE 
RC SETUP 
About the button names in these explanations
[ ] : LCD buttons for selection items Button name only:
Indicates a button on the remote control unit
7Place the remote control units with their signal transmitters facing each other, press NEXT, then immediately press the button on the remote control unit you want to register.
”Success!” is displayed if the code was learned successfully.
8To register other buttons, press NEXT.
bRepeat steps 6 to 8.
9Press [EXIT] to exit the learning mode.
bPress [EDIT] if you want to change the button name. Perform the procedure at “Changing the button name” (v page 18) starting from step 7.
NOTE
The learning function may not work for some remote control units, and sometimes a device may not operate properly even if its remote control signals have been learned. In this case, use the remote control unit included with the device.
Using the Macro function
This function allows you to register a series of operations at a single button.
With this function you can for example turn on the amplifier, select the input source, turn on the TV’s power, turn on the source device’s (equipment) power and set the play mode all by pressing a single button.
1 Press RC SETUP for 3 seconds.
The “PROGRAM DEVICE” menu is displayed.
2Press [MACROS].
3Press [ADD/REDO].
4Press NEXT twice.
5At the “Assign Macro” screen, press the LCD button for the device (equipment) for which you want to register the macro.
6Press the button at which you want to register the macro.
bMacros can be registered at buttons other than NEXT, BACK and DEVICE.
7Press NEXT to register the next signal.
bPress DEVICE to select the device. b Repeat steps 5 to 6.