| Started Getting |
|
|
| Operation |
|
|
function | Network |
Application | PC |
| Troubleshooting |
| Specifications |
LCD button | LCD button |
NEXT
RC SETUP 
About the button names in these explanations
[ ] : LCD buttons for selection items Button name only:
Indicates a button on the remote control unit
Setting the device display mode
Use this procedure to select the way in which the devices (equipment) are displayed.
1 Press RC SETUP for 3 seconds.
The “PROGRAM DEVICE” menu is displayed.
2Press NEXT, then press [EDIT DEVICE].
3Press [DISPLAY MODE].
4Press NEXT.
5At the “Select Device” screen, press the LCD button for the device whose display mode you want to change.
6Press [COLUMN MODE] or [ROW MODE].
[COLUMN MODE] :
The devices are displayed two per row.
[ROW MODE] :
The devices are displayed one per row.
7 Press [YES].
The display mode is set.
bWhen [NO] is pressed, the setting menu reappears. To continue, press [YES].
NOTE
The display mode is not set in the device. Set with respect to the LCD button position.
Setting the remote control code transmission mode (In the case of IR)
1 Press RC SETUP for 3 seconds.
The “PROGRAM DEVICE” menu is displayed.
2Press NEXT, then press [EDIT DEVICE].
3Press NEXT.
4Press [IR/RF].
5Press NEXT.
6At the “Select Device” screen, press the LCD button for the device whose transmission mode you want to change.
7Press NEXT.
8Press [IR].
[IR] :
The codes are sent as infrared signals.
9 Press [YES].
The transmission mode is set.
bWhen [NO] is pressed, the setting menu reappears. To continue, press [YES].
14