8
9Press [SAVE] to register the set macro.
[TEST] :
Press this to send the registered macro to check it.
[– DELAY +] :
Use these to set the transmission interval. This can be set to between “0.05(MIN)” and “60(MAX)”. (Initial setting: 0.25 seconds)
[CANCEL ENTRY] :
Press this to cancel the last code registered and return to the registration mode.
[START OVER] :
Press this to start over from the beginning.
10Press [EXIT] to end the setting.
b Press [EDIT] if you want to change the button name (macro name).
Perform the procedure at “Changing the button name” (vpage 18) starting from step 7.
NOTE
The macro setting button cannot be registered in a macro.
Using the delay time function
The interval at which the remote control signals registered with the system call function are sent (the “delay time”) can be set.
1 Press RC SETUP for 3 seconds.
The “PROGRAM DEVICE” menu is displayed.
2Press [MACROS].
3Press [EDIT DELAY].
4Press NEXT twice.
5The “Edit Macro” screen is displayed. Select a macro that has been registered.
6Press NEXT.
7Use [– DELAY +] to change the delay time, then press [SAVE].
[TEST] :
Press this to send the registered macro to check it.
[– DELAY +] :
Use these to set the transmission interval.
[CREATE AGAIN] :
The macro registration screen reappears.
8Press [EXIT] to end the setting.
Using the code search function
This function lets you search for preset codes when adding new devices (equipment) to the remote control unit.
1 Press RC SETUP for 3 seconds.
The “PROGRAM DEVICE” menu is displayed.
2Press [BASIC SETUP].
3Press [CODE SEARCH].
4Press NEXT.
5At the “Press Device Type” screen, press the LCD button for the device (equipment) whose code you want to search for.
6Press NEXT twice.
7If the device (equipment) operates when the remote control unit’s buttons are pressed, press [YES].
bIf [NO] is pressed, the code switches. Press a remote control unit button again to check. Press [BACK] to return to the previous code.
8At the “Select Position” screen, press the LCD button for the position at which you want to add the preset device (equipment).
bPress [NO] to end, [YES] to continue.
| Started Getting |
|
|
| Operation |
|
|
function | Network |
Application | PC |
| Troubleshooting |
| Specifications |