ENGLISH
[1]Changing the preset memory of preset devices q Touch the liquid crystal display to turn the
display on.
w Press the JOG stick to display the icon display section.
e Press the 
and 
buttons in the icon display section to display the “SETUP” icon.
a.Display the “SETUP” icon in the icon display section, then press this “SETUP” icon for at least 3 seconds to display the setup screen
(a).
Press the “Edit Device” button on the “Setup 1/4” page to display the device selection screen (b).
b.Press the icon in the icon display section for the device whose preset memory you want to change to display the brand selection screen (c).
c.Use the 
and 
buttons on the brand list to display the desired brand, then press the “Brand name” button to display the code selection screen (d).
d.Select and press the code number from the code list. The transmission test screen (e) appears.
e.Press the “ON/OFF” button on the transmission test screen to check the operation of the device. (If the code is right, the power of the device you are attempting to operate should turn on and off.)
If the device has operated, press the “OK” button to select that preset memory.
If the device has not operated, press the “Cancel” button and try a different code.
If the desired preset code is not listed, press the “CANCEL” button on the code selection screen (d) then select “NONE” at the very bottom of the brand selection screen (c).
In this case the preset memory is not set.
f.Once “Setup Successful” (f) appears, the preset memory is set and the device selection screen reappears.
When the “Cancel” button is pressed at the device selection screen, the setup screen reappears. Press any icon other than “SETUP” on the setup screen to cancel the setup mode and return to the transmission screen.
Screen (a)
Screen (c)
Screen (e)
Screen (b)
Screen (d)
Screen (f)
12
