Denon RC-8000 manual Editing registered system call settings, English

rPress the and buttons in the icon display section to display the DVD icon, then press the DVD icon to select it.

Here, press the DVD “ON” and “PLAY” buttons.

To select buttons on other pages, press the JOG switch’s left and right buttons to switch the page.

After the buttons are registered, press the “END” button.

When the “END” button is pressed, the display switches to a confirmation screen.

tThe buttons registered in steps e and r are displayed on the confirmation screen.

Press the “OK” button to register the system call settings. The system call button name switches from gray to black.

The system call signals are stored at the open system call button with the lowest number.

Initially they are stored at “CALL 1”.

[3]Editing registered system call settings

q Press “SETUP” on the icon display section for 3 seconds to display the setup screen.

Press the “Sys. Call Setup” button on the “Setup 3/4” page to display the system call selection screen.

w Press the and buttons on the call list to display the system call button you want to edit.

Press the system call button you want to edit so that it is displayed in half-tone dot mesh, then press the “EDIT” button to set the system call edit mode.

e Editing system call settings e-1 Changing the delay time

By default, the delay time is set to 0.7 seconds.

The delay time can be changed to anything between 0 and 10 seconds in steps of 0.1 second.

The delay times at the right of the buttons indicate the time from which the signal for that button is sent until the signal for the next button is sent.

a.Press the button on the system call editing screen’s button list whose delay time you want to change so that it is displayed in half-tone dot mesh.

b.Press the • and ª buttons at the bottom right of the editing screen to set the desired delay time.

Screen r

Screen q

Screen e

ENGLISH

Screen t

Screen w

21