Speaker Connections

Speakers

(L)(R)

w q w q

Connecting the Speaker Cables

Carefully check the left (L) and right (R) channels and + (red) and – (black) polarities on the speakers being connected to the RCD-CX1, and be sure to interconnect the channels and polarities correctly.

1Peel off about 10 mm of sheathing from the tip of the speaker cable, then either twist the core wire tightly or terminate it.

Turnthespeakerterminal
2counterclockwise to loosen it.

 

3Insert the speaker cable’s core wire to the hilt into the speaker terminal.4Turn the speaker terminal clockwise to tighten it.

NOTE

•Use speakers with an impedance of 4 to 16 Ω/ohms. The protection circuit may be activated if speakers with an impedance other than specified are used.

•Connect the speaker cables in such a way that they do not stick out of the speaker terminals. The protection circuit may be activated if the core wires touch the rear panel or if the + and – sides touch each other (v “Protection circuit”).

•Never touch the speaker terminals while the power supply is connected. Doing so could result in electric shock.

Protection circuit

The protection circuit will be activated in thefollowing cases:

•When the speaker cable’s core wires are touching the rear panel or screws or when the speaker cable’s + and – sides are touching

•When the surrounding temperature is extremely high

•When the internal temperature rises due to extended use with a high output

If this happens, unplug the power cord, then check the connections of the speaker cables and input cables. If the set’s temperature is extremely high, wait for it to cool off and improve surrounding ventilation. After doing this, plug the power cord back in.

If the protection circuit is activated though there are no problems in ventilation around the set or in connections, the set could be damaged. Turn off the power, then contact a DENON servicing and inquiry outlet.

ENGLISH

Connecting the Playback

Components

Record Player

Turntable

"6%*0

(/%

065

 

 

L R

•With some record players, noise may be generated when the ground wire is connected. If so, disconnect the ground wire.

•Set the CARTRIDGE selection switch to “jMM” or “hMC” according to the cartridge being used.

NOTE

The RCD-CX1’s SIGNAL GND terminal is meant to reduce noise when a record player is connected. This is not a safety ground terminal.

Specifications Troubleshooting Functions Other Timer the Setting Playback Setup Connections Started Getting