Personal Memory Plus Function
This function sets the settings (input mode, surround mode, etc.) last selected for the individual input sources. When you switch to an input source, the settings are automatically set to the ones that were set the last time that input source was used.
The surround parameters, tone adjustment and the volumes of the different speakers are stored for the individual surround modes.
Last Function Memory
This stores the settings as they were directly before the standby mode was set.
When the power is turned back on, the settings are restored to as they were directly before the standby mode was set.
Backup Memory
The various settings are backed up for about 1 week, even if the power is turned off or the power cord is disconnected.
Auto Power On
When the power is in the standby mode, the power turns on simply by pressing <5> or <1>.
Resetting the Microprocessor
Perform this procedure if the display is abnormal or if operations cannot be performed.
When the microprocessor is reset, all the settings are reset to their default values.
1Set the standby mode using <ON/STANDBY> .b Set to the standby mode and wait 5 seconds.
2Press <ON/STANDBY>while simultaneously pressing<FUNCTION> and <8>.
3Once the display starts flashing at intervals of about 1 second, release the three buttons.
If in step 3 the display does not flash at intervals of about 1 second, start over from step 1.
ENGLISH
Troubleshooting Information Control Remote Playback Setup Connections Started Getting
39