Cautions on Loading Discs

•Only load one disc at a time. Loading two or more discs can damage the unit or scratch the discs.

•Do not use cracked or warped discs or discs that have been repaired with adhesive, etc.

•Do not use discs on which the sticky part of cellophane tape or labels is exposed or on which there are traces of where labels have been removed. Such discs can get caught inside the player and damage it.

Cautions on Handling

•Do not get fingerprints, oil or dirt on discs.

•Take special care not to scratch discs when removing them from their cases.

•Do not bend or heat discs.

•Do not enlarge the hole at the center.

•Do not write on the labeled (printed) surface with ball-point pens, pencils, etc., or stick new labels on discs.

•Water droplets may form on discs if they are moved suddenly from a cold place (outdoors for example) to a warm place, but do not try to dry them off using a hairdryer, etc.

Cautions on Storing Discs

•Be sure to remove discs after using them.

•Be sure to store discs in their cases to protect them from dust, scratches, warping, etc.

•Do not store discs in the following places:

1.Places exposed to direct sunlight for long periods of time

2.Dusty or humid places

3.Places exposed to heat from heating appliances, etc.

Cleaning Discs

•If there are fingerprints or dirt on discs, wipe them off before using the disc. Fingerprints and dirt can impair sound quality and cause interruptions in playback.

•Use a commercially available disc cleaning set or a soft cloth to clean discs.

Gently wipe the disc from the

Do not wipe with a circular

inside towards the outside.

motion.

NOTE

Do not use record spray, antistatic agents, or benzene, thinner or other solvents.

About the Remote Control Unit

Inserting the Batteries

q Slide the rear lid in the

w Load the two batteries properly

direction of the arrow and

as indicated by the marks in the

remove it.

battery compartment.

ePut the rear cover back on.

ENGLISH

NOTE

Getting

• Replace the batteries with new ones if the set does not operate even

 

when the remote control unit is operated close to the unit.

Started

• The supplied batteries are only for verifying operation.

 

• When inserting the batteries, be sure to do so in the proper direction,

 

following the “q” and “w” marks in the battery compartment.

Connections

• To prevent damage or leakage of battery fluid:

 

• Do not use a new battery together with an old one.

 

• Do not use two different types of batteries.

 

• Do not attempt to charge dry batteries.

 

• Do not short-circuit, disassemble, heat or dispose of batteries in

Setup

flames.

• If the battery fluid should leak, carefully wipe the fluid off the inside

of the battery compartment and insert new batteries.

Playback

• Remove the batteries from the remote control unit if it will not be in

 

use for long periods.

 

• When replacing the batteries, have the new batteries ready and

 

insert them as quickly as passible.

Remote

Operating Range of the Remote Control

Control

Unit

 

Point the remote control unit at the remote sensor when operating it.

Information

 

Approx. 23 feet/7 m

Troubleshooting

 

30°

 

30°

 

NOTE

The set may function improperly or the remote control unit may not operate if the remote control sensor is exposed to direct sunlight, strong artificial light from an inverter type fluorescent lamp or infrared light.