Desa BC55T, BC40, BC70T Assembly, FOR 40, 55T, AND 70T MODELS ONLY, FOR 115T AND 165T MODELS ONLY

ASSEMBLY

(FOR 40, 55T, AND 70T MODELS ONLY)

These models are furnished with a nose cone guard. Nose cone guard and mounting screws are found in the shipping carton.

Tools Needed

• 5/16" Nut Driver or Wrench

1.Place nose cone guard on top of upper shell flange. Make sure nose cone guard is on hot air outlet end of heater.

2.Insert screws through nose cone guard and upper shell flange.

3.Tighten screws firmly.

Nose Cone

Guard

Screw

Hot Air

Outlet

Upper Shell

Flange

(FOR 115T AND 165T MODELS ONLY)

These models are furnished with wheels and a front handle. Some models are furnished with a rear handle also. Wheels, handle(s), and the mounting hardware is found in the shipping carton.

Tools Needed

•Medium Phillips Screwdriver

•3/8" Open or Adjustable Wrench

•Hammer

1.Slide axle through wheel support frame. Install wheels on axle.

IMPORTANT: Place extended hub of wheel toward wheel support frame.

2.Place cap nuts on axle ends. Gently tap with hammer to secure.

3.Place heater on wheel support frame assem- bly. Make sure air inlet end of heater is over wheels.

4.Place front handle on top of fuel tank flange. Insert screws through handle(s), fuel tank flange and wheel support frame. Attach nut finger tight after each screw is inserted.

5.Tighten all nuts firmly.

	Front
	Handle	Rear Handle
		(If Equipped)
Hot Air	Screw
Outlet

Figure 4 - Nose Cone Guard Assembly,

40/55T/70T Models Only

Fuel Tank		Air Inlet
Flange
Wheel
Support
Frame
Wheel
		Extended Hub
Cap Nut	Nut	Axle
Figure 5 - Wheel and Handle Assembly,
	115T/165T Models Only

4 www.desatech.com 111168-01A