Desa UKC55CT Assembly, For 40, 55 and 70 Models only, For 115 and 165 Models only, Tools Needed

ASSEMBLY

(FOR 40, 55 AND 70 MODELS ONLY)

These models are furnished with a nose cone guard. Nose cone guard and mounting screws are found in the shipping carton.

Tools Needed

• 5/16" nut driver or wrench

1.Place nose cone guard on top of upper shell flange. Make sure nose cone guard is on hot air outlet end of heater.

2.Insert screws through nose cone guard and upper shell flange.

3.Tighten screws firmly.

Nose Cone

Guard

Screw

Hot Air

Outlet

Upper Shell

Flange

Figure 6 - Nose Cone Guard Assembly, 40/55/70 Models Only

(FOR 115 AND 165 MODELS ONLY)

These models are furnished with wheels and a handle. Some models are furnished with a second handle also. Wheels, handle(s), and the mounting hardware are found in the shipping carton.

Tools Needed

•Medium Phillips Screwdriver

•3/8" Open or Adjustable Wrench

•Hammer

1.Slide axle through wheel support frame. Install wheel spacers if provided. Install wheels on axle.

IMPORTANT: When installing wheels, point extended hub of wheels toward wheel support frame (see Figure 7).

2.Place cap nuts on axle ends. Gently tap with hammer to secure.

3.Place heater on wheel support frame. Line up holes on fuel tank flange with holes on wheel support frame. Be sure wheels are mounted under the air inlet of heater.

4.Place handle(s) on top of fuel tank flange. In- sert screws through handle(s), fuel tank flange, and wheel support frame. Attach nut finger tight after each screw is inserted. If only one handle is provided, be sure to mount handle over outlet end of heater.

5.After all screws are inserted, tighten nuts firmly.

Handle	Cord Cleat with Bolts
	and Nuts (If provided)
	Handle (If
	provided)
Screw
Hot Air
Outlet	Air
Fuel	Inlet
Tank
Flange
Wheel Support
Frame

Nut

Cap Nut

Wheel

Axle	Extended
	Hub
Wheel Spacer
(If Provided)

Figure 7 - Wheel and Handle Assembly,

115/165 Models Only

116170-01A www.desatech.com 5