12
INSTALLATION
Installing Blower Assembly - GA3450T (Cont.) Connecting to Gas Supply
INSTALLATION
Continued
5.Test to make sure the blower is working properly.
6.Reinstall hood assembly (see pages 9 and 10) and close lower louver door.
7.Place log set back on the unit.
Blower Bracket
Assembly
Screw
Switch |
|
|
|
|
| Strain | Wire |
| |
| Relief | Harness |
| |
| Power Cord |
| ||
Blue | Red | Outlet |
| |
| Receptacle |
| ||
Switch |
|
| ||
|
|
|
| |
Plate |
|
| Shield |
|
|
|
| Cover |
|
Blower |
|
|
|
|
Control |
|
|
|
|
Shield |
|
|
|
|
Clamp Connector |
| Wire |
| |
(not included) |
| Harness |
| |
Figure 18 - Installing Blower Bracket Assembly | ||||
| Fan Switch |
| ||
| (Auto/Off/On) |
| ||
| 1 |
| Auto | Thermostat |
| Off 2 |
| Blue | |
| 3 | Switch | ||
|
|
| (N.O.) | |
|
|
|
| |
110/115 |
| On | Blue Blower | |
|
|
| ||
V.A.C. | Black | Red | Motor | |
| Red | |||
| Green |
|
|
|
| White |
|
| White |
|
|
|
| Green |
Figure 19 - Wiring Diagram For Fan Accessory Built-In Installation
CONNECTING TO GAS SUPPLY
WARNING: This appliance requires a 1/2" NPT (National Pipe Thread) inlet connection to the pres- sure regulator.
WARNING: A qualified service person must con- nect fireplace to gas supply. Follow all local codes.
CAUTION: Never connect propane/LP fireplace directly to the propane/LP supply. This fireplace requires an external regulator (not supplied). Install the external regulator between the fireplace and pro- pane/LP supply.
WARNING: Never connect natural gas fireplace to private
Installation Items
Before installing fireplace, make sure you have the items listed below.
•external regulator - propane/LP only (supplied by installer)
•piping (check local codes)
•sealant (resistant to propane/LP gas)
•equipment shutoff valve *
•ground joint union
•sediment trap
•tee joint
•pipe wrench
•test gauge connection*
*A CSA
Note: If desired, purchase a
For propane/LP units, the installer must supply an external regula- tor. The external regulator will reduce incoming gas pressure. You must reduce incoming gas pressure to between 11 and 14 inches of water. If you do not reduce incoming gas pressure, fireplace regu- lator damage could occur. Install external regulator with the vent pointing down as shown in Figure 20, page 13. Pointing the vent down protects it from freezing rain or sleet.
For..com