10
INSTALLATION
INSTALLATION
Continued
WARNING: Do not allow any combustible materi- als to overlap the firebox front facing.
IMPORTANT: Noncombustible materials such as brick, tile, etc. may overlap the front facing, but should never cover any necessary openings like louvered slots.
WARNING: Do not allow noncombustible materials to cover any necessary openings like louvered slots.
WARNING: Never modify or cover the louvered slots on the front of the firebox.
WARNING: Use only noncombustible mortar or adhesives when overlapping the front facing with noncombustible facing material.
| 10" |
| ||
Note: All vertical | 8" |
|
| |
6" |
|
| ||
measurements are |
|
| ||
from top of fireplace | 2 | 1 | /2" |
|
opening to bottom of |
|
| ||
|
|
|
| |
mantel shelf. All |
|
|
|
|
measurements are in |
|
|
|
|
inches. |
|
|
|
|
Side of |
|
| 13" | 16" |
|
|
|
| |
Firebox
Mantel Shelf
19" |
| 21" |
| ||
|
|
|
MANTEL CLEARANCES FOR BUILT-IN INSTALLATION
If placing mantel above
NOTICE: Surface temperatures of adjacent walls and mantels become hot during operation. Walls and mantels above the firebox may become hot to the touch. If installed properly, these temperatures meet the requirement of the national product standard. Follow all minimum clearances shown in this manual.
NOTICE: If your installation does not meet the mini- mum clearances shown, you must do one of the following:
•raise the mantel to an acceptable height
•remove the mantel
Figure 12 - Minimum Mantel Clearances for Built-In Installation
OPTIONAL MANTEL INSTALLATION
Note: Refer to instructions provided with the mantel for assembly instructions. Refer to instructions below for system installation. Refer to instructions on page 4 for firebox assembly. Blower accessory should be installed if it is being used (see Installing Blower Accessory GA3450T, pages 11 through 13).
1.Unscrew four brass screws that attach top louver to fireplace. Remove louver from fireplace and set aside.
2.Place fireplace on wood base.
3.Place mantel around fireplace/base assembly.
4.Assemble brass trim kit. See Assembling Brass Trim, page 11.
5.Firmly snap brass trim kit on shoulder screws. Shoulder screws are located on fireplace cabinet (see Figure 13).
Shoulder Screws
Hole for 3" 
Wood Screw for Attaching Fireplace to Mantel
| Hole for 3" | |
| Wood Screw | |
Assembled Brass Trim | for Attaching | |
Fireplace to | ||
| ||
| Wooden Base |
Figure 13 - Attaching Brass Trim to Fireplace
For
.
.com
