OWNER’S MANUAL
INSTALLATION
Continued
INSTALLING LOGS (CGD3924PR)
WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.
CAUTION: After installation and periodically thereafter, check to ensure that no flame comes in contact with any log. If so, repo- sition logs according to the log installation instructions in this manual. Flames contacting logs will create soot.
Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.
1.Locate pegs on the bottom of back log (#1). Slide these pegs into the holes in the grate base behind the burner (see Figure 18).
2.Place the base of the middle log (#2) in the
3.Locate the recesses on the back of the front log (#3). Fit these recesses be- tween the posts of the grate base (see Figure 20).
4.Locate the notches in the bottom of the crossover log (#4). Place the crossover log on top of the middle log and front log. Make sure the notches of the cross- over log lines up with rectangular knobs on top of the middle and front logs (see Figure 21).
5.Add lava rock around base of heater. Do not place any lava rock on logs or burner.
Back Log (#1)
Peg
Hole in 
Grate Base
Burner
Figure 18 - Installing Back Log (#1)
Middle Log (#2)
Tab
Burner
Cutout
“U” Bend
Slot
Figure 19 - Installing Middle Log (#2)
Front Log (#3)
Post
PostRecess
Figure 20 - Installing Front Log (#3)
Crossover Log (#1)
Notches
Rectangular
Knobs
Figure 21 - Installing Crossover Log (#4)
Continued
104307 | 13 |
