OWNER’S MANUAL
OPERATING HEATER
Continued
Shows Temperature Setting
Allows Burners to be Turned On and Off with the Hand- Held Remote Unit.
The log heater will automati- cally cycle between pilot and the heat setting that has been selected.
HI
TEMP
MAN LO ON
AUTO OFF
STATUS
Increases Room Temperature
Decreases Room Temperature
Turns Burners On and Off
Shows Current Operation Mode
CLEANING AND MAINTENANCE
WARNING: Turn off heater and let cool before cleaning.
CAUTION: You must keep control areas, burner, and circu- lating air passageways of heater clean. Inspect these areas of heater before each use. Have heater inspected yearly by a quali- fied service person. Heater may need more frequent cleaning due to excessive lint from carpeting, pet hair, etc.
Figure 29 - Thermostat Hand-Held Remote Control Unit Selections
ODS/PILOT AND BURNER
INSPECTING
BURNERS
Check pilot flame pattern and burner flame patterns often.
PILOT FLAME PATTERN
Figure 30 shows a correct pilot flame pat- tern. Figure 31 shows an incorrect pilot flame pattern. The incorrect pilot flame is not properly heating the thermocouple. When the thermocouple cools, the heater will shut down.
Pilot Burner | Thermocouple |
|
Figure 30 - Correct Pilot Flame Pattern
Pilot Burner
Thermocouple
Figure 31 - Incorrect Pilot Flame Pattern
If pilot flame pattern is incorrect, as shown in Figure 31
•turn heater off (see To Turn Off Gas to Appliance, page 16)
•seeTroubleshooting, pages 18 through 20
MAIN BURNER
Periodically inspect all burner flame holes with the heater running. All slotted burner flame holes should be open with yellow flame present. All round burner flame holes should be open with a small blue flame present. Some burner flame holes may be- come blocked by debris or rust, with no flame present. If so, turn off heater and let cool. Either remove blockage or replace burner. Blocked burner flame holes will create soot.
•Use a vacuum cleaner or small, soft bristled brush to clean.
LOGS
•If you remove logs for cleaning, refer to Installing Logs, pages 13 and 14, to prop- erly replace logs.
•Replace log(s) if broken or chipped
BURNER PRIMARY AIR HOLE
Air is drawn into the burner through the 8 holes in the brass fitting at the burner en- trance. There holes may become blocked with dust or lint. Periodically inspect these holes for any blockage and clean if needed. Blocked air holes will create soot.
MAIN BURNER
Periodically inspect all burner flame holes with the heater running. All slotted burner flame holes should be open with yellow flame present. All round burner flame holes should be open with a small blue flame present. Some burner flame holes may be- come blocked by debris or rust, with no flame present. If so, turn off heater and let cool. Either remove blockage or replace burner. Blocked burner flame holes will create soot.
104307 | 17 |
