Desa CGEFP33PR, CGEFP33NR, EFP33PR, EFP33NR, VTGF33NR, VTGF33PR Installing Logs VTGF33NR/VTGF33PR

INSTALLATION

Assembling And Attaching Optional Brass Trim (Cont.)

Installing Hood

Installing Logs (VTGF33NR/VTGF33PR)

21

INSTALLATION

Continued

Set Screws

INSTALLING LOGS (VTGF33NR/VTGF33PR)

Side Brass	Adjusting
Trim	Plate

Slot

Shim

Slot

Mitered Edge

Figure 38 - Assembling Brass Trim

Assembled

Brass Trim

Top Brass Trim

Trim

Hanging

Screws

Hanging Notches on Trim

WARNING: Failure to position the parts in accor- dance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.

CAUTION: Do not remove the warning and in- struction labels attached to the heater base assem- bly. These markings contain important warranty in- formation.

CAUTION: After installation and periodically there- after, check to ensure that no flame comes in contact with any log. With the heater set to High, check to see if flames contact any log. If so, reposition logs ac- cording to the log installation instructions in this manual. Flames contacting logs will create soot.

Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.

1. Place front logs (#1a and #1b) on top of the grate. Make sure

the notches in the bottom of the log fit over the grate prongs

(see Figure 41). Push back of log flush with metal grate bar.

Figure 39 - Attaching Brass Trim to Fireplace (EFP33PR Shown)

INSTALLING HOOD

Install hood to top of firebox as shown in Figure 40. Use 3 Phillips screws provided.

Figure 40 - Installing Hood to Firebox (EFP33PR Shown)

2.	Rest middle log (#2) behind metal posts on front burner. Make
	sure the grooves in the bottom of the log fit over the grate.
	Bring the log forward next to the metal posts (see Figure 42).
3.	Slide the grooves in the back of the rear log (#3) against the
	rear grate prongs. Make sure the peg on the log is on top (see
	Figure 43, page 22).
4.	Place the crossover log (#4) on the rear log and the middle log.
	Make sure the peg on the rear log is in the hole in the bottom
	of the crossover log. The crossover log should fit in the cutout
	of the middle log (see Figure 44, page 22).

Front Log (#1a) Middle Log (#2)

	Front Log
	(#1b)
	Groove
Notch	Metal
	Post
Grate
Prongs	Groove
Metal	Grate
Grate Bar	Metal Post

Figure 41 - Installing Front	Figure 42 - Installing Middle
Logs (#1a and #1b)	Log (#2)

For morevisit www..com

108117-01G