Desa CGF265PVA, CGF280PT Installing, Continued, Mantel Clearances for Built-InInstallation

INSTALLING	Mantel Clearances for Built-In Installation
Continued	If placing mantel above built-in fireplace, you must meet minimum clearance
	between mantel shelf and top of fireplace opening.
			Mantel Shelf
	10"					Underside of
	8"
						Mantel Shelf
	6"
	2 1/2"					All minimum
						distances are
						in inches
		20"	241/2"	271/2"	30"
						Top of
						Fireplace
		Distances to				Opening
		Underside of
		Mantel

Figure 15 - Minimum Mantel Clearances for Built-In Installation

If your installation does not meet the above minimum clearances, you must:

•raise the mantel to an acceptable height, OR

•remove the mantel.

INSTALLING GAS PIPING TO FIREPLACE LOCATION

NOTICE

A qualified service person must connect fireplace to gas supply.

Follow all local codes.

CAUTION

Never connect heater directly to the propane/LP supply. This heater requires an external regulator (not supplied). Install the external regulator between the heater and propane/LP supply.

Installation Items Needed

Before installing fireplace, make sure you have the items listed below.

•	external regulator (supplied by	•	sediment trap
	installer, see Figure 16, page 16)	•	tee joint
•	piping (check local codes)	•	pipe wrench
•	sealant (resistant to LP gas)	•	approved flexible gas line with
•	manual shutoff valve *		gas connector (if allowed by
•	test gauge connection *		local codes) (not provided)

*An A.G.A. design-certified manual shutoff valve with 1/8" NPT tap is an acceptable alternative to test gauge connection. Purchase the optional A.G.A. design-certified manual shutoff valve from your dealer. See Accessories, page 38.

Continued 15

102665