Desa VGMRN, CGMFN, CGMFP, VGMRP Installation, Pipe Nipple Cap Tee Joint Sediment Trap

Models: VGMRN VGMRP CGMFN CGMFP

1 36
Download 36 pages 22.81 Kb
Page 14
Image 14
Pipe Nipple Cap Tee Joint

INSTALLATION

Continued

We recommend that you install a sediment trap in supply line as shown in Figure 14. Locate sediment trap where it is within reach for cleaning. Install in piping system between fuel supply and heater. Locate sediment trap where trapped matter is not likely to freeze. A sediment trap traps moisture and contaminants. This keeps them from going into fireplace controls. If sediment trap is not installed or is installed wrong, fireplace may not run properly.

CSA Design-

 

Certified Equipment

 

Shutoff Valve With

 

1/8" NPT Tap*

Propane/LP

 

 

From External

 

Regulator (11"

 

W.C.** to 14"

 

W.C. Pressure)

Approved

Natural

Flexible Gas

From Gas Meter

Line

(5" W.C.** to

 

 

10.5" W.C.

3" Minimum

Pressure)

 

Pipe Nipple Cap Tee Joint

Sediment Trap

Figure 14 - Gas Connection

* Purchase the optional CSA design-certified

1.Route flexible gas line, included, from fire- place control to equipment shutoff valve through side or rear access holes in outer casing (see Figure 1, page 5).

2.Apply pipe joint sealant lightly to male threads of gas connector attached to flexible gas line/ equipment shutoff valve (see Figure 15).

CONNECTING Fireplace to Gas Supply CAUTION: Avoid damage to regulator. Hold gas regulator with wrench when connecting it to gas piping and/or fittings (Manual-Controlled Models Only).

Manual background CAUTION: Avoid damage to gas control. Hold gas control with wrench when connecting it to gas piping and/or fittings (Remote-Ready Models Only).

3.Check all gas connections for leaks. See

Checking Gas Connections.

4.Feed flexible gas line into fireplace base area while replacing branch support. Make sure the entire flexible gas line is in fireplace base area.

To Gas Regulator (Manual-Controlled Models) or Control

Valve (Remote-

Ready Models) Equipment

Shutoff Valve

equipment shutoff valve from your dealer. See

Accessories, page 34.

CONNECTING Fireplace to Gas Supply

Installation Items Needed

• Phillips screwdriver

• sealant (resistant to propane/LP gas, not

Flexible Gas Line Manual background from Fireplace Gas Regulator Provided

With Fireplace

Propane/LP

To External

Regulator

Natural

To Gas Supply

provided)

NOTICE: Most building codes do not permit concealed gas connections. A flexible gas line is provided to allow acces- sibility from the fireplace (see Figure 1, page 5). The flexible gas supply line connection to the equipment shutoff valve should be accessible.

Figure 15 - Attaching Flexible Gas Line

to Equipment Shutoff Valve

14

www.desatech.com

119315-01A

Page 14
Image 14
Desa VGMRN, CGMFN, CGMFP, VGMRP Installation, Pipe Nipple Cap Tee Joint Sediment Trap, CONNECTING Fireplace to Gas Supply