Desa CGMFP Cleaning and Maintenance, Troubleshooting, LOG Set, Cabinet, Observed Problem, Remedy

Cleaning and

Maintenance

Continued

Pilot Air

Inlet Hole

Pilot Assembly

Figure 41 - Pilot Inlet Air Hole

(Propane/LP Gas)

Pilot Air

Inlet Hole

Pilot Assembly

Figure 42 - Pilot Inlet Air Hole

(Natural Gas)

LOG Set

•If you remove one-piece log set for cleaning, refer to Installing Log Set and Screen, page 18, for placement instructions.

•Replace log set if broken or chipped (dime-sized or larger).

CABINET

Air Passageways

Use pressurized air to clean.

Exterior

Use a soft cloth dampened with a mild soap and water mixture. Wipe the cabinet to remove dust.

Troubleshooting

WARNING: Turn off and unplug fireplace and let cool before servicing. Only a qualified service person should service and repair fireplace.

CAUTION: Never use a wire, needle or similar object to clean ODS/pilot. This can damage ODS/pilot unit.

Note: All troubleshooting items are listed in order of operation.

OBSERVED PROBLEM	POSSIBLE CAUSE		REMEDY
When ignitor button is pressed,	1. Ignitor electrode not con-		1.	Reconnect ignitor cable
there is no spark at ODS/pilot	2.	nected to ignitor cable	2.	Free ignitor cable if pinched
		Ignitor cable pinched or wet
				by any metal or tubing. Keep
	3.	Broken ignitor cable	3.	ignitor cable dry
				Replace ignitor cable
	4.	Bad ignitor	4.	Replace ignitor
	5.	Ignitor electrode positioned	5.	Replace pilot assembly
	6.	wrong	6.	Replace pilot assembly
		Ignitor electrode broken
	7.	Battery not installed, battery	7.	Install new alkaline battery in
		power low or battery not		electronic ignitor. Verify bat-
		installed correctly		tery is installed correctly

119315-01A www.desatech.com 25