![](/images/new-backgrounds/1027649/2764919x1.webp)
CHECKING GAS
CONNECTIONS | Control Valve Location |
Continued |
|
Propane/LP |
|
Supply Tank |
|
Manual
Shutoff
Valve
Figure 15 - Checking Gas Joints
4. Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow “B” in the safety in- formation in the first column. If you don’t smell gas, go to the next step.
5. Press in control knob and turn coun- | |
terclockwise | to the PILOT |
position. Keep control knob pressed | |
in for five (5) seconds (see Figure 16). | |
Note: You may be running this | |
heater for the first time after hook- | |
ing up to gas supply. If so, the con- | |
trol knob may need to be pressed in | |
for 30 seconds. This will allow air to | |
bleed from the gas system. | |
• If control knob does not pop up | |
when released, contact a qualified | |
service person or gas supplier for | |
repairs. |
|
6. With control knob pressed in, push | |
down and release ignitor button. This |
OPERATING
HEATER
FOR YOUR SAFETY
READ BEFORE
LIGHTING
WARNING: If you do not fol- low these instructions exactly, a fire or explosion may result caus- ing property damage, personal injury or loss of life.
A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions ex- actly.
B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•Do not try to light any appliance.
•Do not touch any electric switch; do not use any phone in your building.
•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
•If you cannot reach your gas sup- plier, call the fire department.
C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don’t try to repair it, call a qualified service technician or gas supplier. Force or attempted repair may result in a fire or explosion.
D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been un- der water.
LIGHTING
INSTRUCTIONS
1.STOP! Read the safety information above.
2.Make sure manual shutoff valve is fully open.
3. Turn control knob clockwise Clockwise to the OFF position.
Ignitor Button | Control Knob |
LOW | PILOT |
| OFF |
HIGH |
|
IGNITOR |
|
Figure 16 - Control Knob In The OFF Position
will light pilot. The pilot is attached |
to the front of burner. The burner |
and pilot are located behind the heat |
shield. If needed, keep pressing igni- |
tor button until pilot lights. |
Note: If pilot does not stay lit, refer |
to Troubleshooting, pages 12 through |
14. Also contact a qualified service |
person or gas supplier for repairs. |
Until repairs are made, light pilot |
with match. To light pilot with match, |
see Manual Lighting Procedure, |
page 11. |
Thermocouple | Ignitor Electrode | |
Pilot Burner | ||
|
Figure 17 - Pilot
7.Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release control knob.
Note: If pilot goes out, repeat steps 3 through 7.
Continued
10 | 103569 |