Desa CGP20L, RP30D installation manual Connecting to GAS Supply, Placing Heater On Mounting Bracket

Models: RP30D CGP20 CGP20L

1 24
Download 24 pages 14.62 Kb
Page 8
Image 8

BLUE-FLAME CGP20, CGP20L AND RP30D

VENT-FREE PROPANE/LP GAS HEATER

INSTALLING TO WALL

Continued

Placing Heater On Mounting Bracket

1.Locate two horizontal slots on back panel of heater.

2.Place heater onto mounting bracket. Slide horizontal slots onto stand-out tabs on mounting bracket.

Horizontal

Slots

7.Hold spacer in place with one hand. With other hand, insert mounting screw through bottom mounting hole and spacer. Place tip of screw in opening of wall anchor or drilled hole.

8.Tighten both screws until heater is firmly secured to wall. Do not over tighten.

Note: Do not replace front panel at this time. Replace front panel after making gas connections and checking for leaks (see pages 8-9).

CONNECTING TO GAS SUPPLY

CAUTION: Use only new, black iron or steel pipe. Inter- nally-tinned copper tubing may be used in certain areas. Check your local codes. Use pipe of 1/2" diameter or greater to allow proper gas volume to heater. If pipe is too small, undue loss of pressure will occur.

Typical Inlet Pipe Diameters

20,000 Btu/Hr models

3/8" or greater

30,000 Btu/Hr models

1/2" or greater

Installation must include a manual shutoff valve, union, and plugged 1/8" NPT tap. Locate NPT tap within reach for test gauge hook up. NPT tap must be upstream from

Stand-Out Tab

Mounting Bracket

(attached to wall)

 

Figure 10 - Mounting Heater Onto Mounting Bracket

Installing Bottom Mounting Screws

1.Locate two bottom mounting holes. These holes are near bottom on back panel of heater (see Figure 11).

Figure 11 - Installing Bottom Mounting Screws

2.Mark screw locations on wall.

3.Remove heater from mounting bracket.

4.If installing bottom mounting screws into hollow or solid wall, install wall anchors. Follow steps 1 through 4 un- der Attaching To Wall Anchor Method, page 7.

If installing bottom mounting screw into wall stud, drill holes at marked lo- cations using 9/64" drill bit.

5.Replace heater onto mounting bracket.

6.Place spacers between bottom mount- ing holes and wall anchor or drilled hole.

NOTICE: A qualified service per- son must connect heater to gas supply. Follow all local codes.

CAUTION: Never connect heater directly to the propane/LP supply. This heater requires an external regulator (not supplied). Install the external regulator be- tween the heater and propane/LP supply.

The installer must supply an external regu- lator. The external regulator will reduce incoming gas pressure. You must reduce incoming gas pressure to between 11 and 14 inches of water. If you do not reduce incom- ing gas pressure, heater regulator damage could occur. Install external regulator with the vent pointing down as shown in Figure

12.Pointing the vent down protects it from freezing rain or sleet.

Propane/LP

Supply Tank

External

Regulator

Vent

Pointing

Down

Figure 12 - External Regulator with Vent Pointing Down

heater (see Figure 13, page 9).

Apply pipe joint sealant lightly to male threads. This will prevent excess sealant from going into pipe. Excess sealant in pipe could result in clogged heater valves.

CAUTION: Use pipe joint seal- ant that is resistant to liquid pe- troleum (LP) gas.

Install sediment trap in supply line as shown in Figure 13, page 9. Locate sediment trap where it is within reach for cleaning. Locate sediment trap where trapped matter is not likely to freeze. A sediment trap traps mois- ture and contaminants. This keeps them from going into heater controls. If sediment trap is not installed or is installed wrong, heater may not run properly.

Continued

8

103569

Page 8
Image 8
Desa CGP20L, RP30D Connecting to GAS Supply, Placing Heater On Mounting Bracket, Installing Bottom Mounting Screws

RP30D, CGP20, CGP20L specifications

Desa CGP20L, CGP20, and RP30D are advanced generators designed for maximum efficiency, reliability, and versatility. These units cater to a wide range of applications, making them a solid choice for both residential and commercial use.

The Desa CGP20L is a portable generator that delivers reliable power in a compact design. With a robust 20,000 watts capacity, it ensures that users can run multiple appliances simultaneously without compromising performance. It features a powerful engine that provides consistent power output, making it ideal for outdoor events, construction sites, or as backup power during outages. The CGP20L is equipped with an easy-to-read digital display that provides critical information about power usage and operating status.

In terms of fuel efficiency, the CGP20L incorporates a technology that minimizes fuel consumption while maximizing output. This feature not only reduces running costs but also lowers emissions, making it an environmentally friendly option. The generator also comes with multiple outlets, ensuring compatibility with a vast array of devices, further enhancing its versatility.

The CGP20 model is another notable offering from Desa, featuring a slightly lower capacity at 18,000 watts. It combines portability with power, designed to be lightweight yet durable. The generator boasts a quiet operation, thanks to advanced sound-dampening technologies. It is particularly well-suited for residential use, including during home improvement projects, recreational activities, or emergency situations. The CGP20 also prioritizes user safety, featuring circuit protection mechanisms to prevent overloads.

On the other hand, the RP30D is designed for heavy-duty use, offering an impressive 30,000-watt capacity. This model is ideal for industrial applications, construction sites, and large events where a significant power supply is necessary. The RP30D incorporates advanced control systems that enhance performance and operational efficiency. It is also designed with rugged features, ensuring resilience in harsh conditions.

All models are designed with user-friendly controls, ensuring ease of operation irrespective of technical expertise. They also prioritize serviceability, facilitating quick maintenance and reducing downtime. With durability, efficiency, and advanced technology at their core, the Desa CGP20L, CGP20, and RP30D generators stand out as reliable solutions for diverse power needs. Whether for personal, commercial, or industrial use, these generators deliver performance you can trust.