INSTALLING TO WALL
NOTICE: A qualified service per- son must install heater. Follow all local codes.
CHECK GAS TYPE
Use only propane/LP gas. If your gas supply is not propane/LP, do not install heater. Call dealer where you bought heater for proper type heater.
INSTALLATION ITEMS
Before installing heater, make sure you have the items listed below.
•external regulator (supplied by installer, see page 8)
•piping (check local codes)
•sealant (resistant to propane/LP gas)
•manual shutoff valve *
•ground joint union
•test gauge connection * (see Figure 13, page 9)
•sediment trap
•tee joint
•pipe wrench
*An A.G.A. design certified manual shutoff valve with 1/8" NPT tap is an acceptable alternative to test gauge connection. Pur- chase the optional A.G.A. design certi- fied manual shutoff valve from your dealer. See Accessories, page 17.
LOCATING HEATER
This heater is designed to be mounted on a wall.
WARNING: Maintain the mini- mum clearances shown in Figure
4.If you can, provide greater clear- ances from floor, ceiling, and join- ing wall.
You can locate model CGP20 and CGP20L on floor, away from a wall. An optional
WARNING: Never install the heater
•in a bedroom or bathroom
•in a recreational vehicle
•where curtains, furniture, clothing, or other flammable objects are less than 36 inches from the front, top, or sides of the heater
•as a fireplace insert
•in high traffic areas
•in windy or drafty areas
CAUTION: This heater cre- ates warm air currents. These cur- rents move heat to wall surfaces next to heater. Installing heater next to vinyl or cloth wall cover- ings or operating heater where impurities in the air (such as to- bacco smoke) exist, may discolor walls.
CEILING
6"
Minimum
From
Sides Of
Heater
Left
Side
FLOOR
IMPORTANT:
CAUTION: If you install the heater in a home garage
•heater pilot and burner must be at least 18 inches above floor
•locate heater where moving vehicle will not hit it
For convenience and efficiency, install heater
•where there is easy access for operation, inspection, and service
•where strong wind gusts from an open door or garage door can not blow directly into heater.
An optional fan kit is available from your dealer. See Accessories, page 17. If plan- ning to use fan, locate heater near an electri- cal outlet.
36" Minimum
Right
Side
*Minimum To Floor
*163/4" - RP30D
*3" - CGP20(L)
floor mounting stand is needed. Purchase the floor mounting stand from your dealer. See Accessories, page 17.
Figure 4 - Mounting Clearances As Viewed From Front of Heater
Continued
6 | 103569 |
