OWNER’S MANUAL
OPTIONAL POSI- TIONING OF THER- MOSTAT SENSING BULB
For Masonry and Factory- built Metal Fireplace
If your log set cycles to pilot, but the room temperature drops to a lower than ideal comfort level before the log set comes back on, you may want to repositionthethermostatsensingbulb.
The thermostat sensing bulb is located near the gas valve assembly on the mounting bracket. This location allows the thermostat to keep the room temperature at an ideal comfort level for most fireplace applica- tions. For positioning the thermostat sens- ing bulb elsewhere, an
4.The mounting clip must be a minimum of 3" from bottom of fireplace to pre- vent crimping of capillary. Once you have decided on a location, clean the area thoroughly. Remove the paper backing from the adhesive on back of mounting clip. Press the clip into the new location so that the thermostat sensing bulb will be positioned verti- cally with the capillary at the bottom (see Figure 44). Slide the thermostat sensing bulb into the clip.
IMPORTANT: Do not crimp capillary.
Gas Valve
Assembly
Thermostat
Sensing Bulb
Adhesive- backed Mounting Clip
Figure 41 - Locating Thermostat Sensing Bulb on Masonry Fireplace
Thermostat
Sensing
Bulb
Adhesive- backed Mounting Clip
Tools needed: 1/4" hex driver or socket
1. Remove logs. Locate the gas valve as- |
sembly and thermostat sensing bulb |
(see Figure 38). |
2. With 1/4" hex driver or socket, loosen |
the thermostat screw. Carefully slide |
the thermostat sensing bulb out of the |
retaining clamp (see Figure 40). |
Note: Do not remove the screw. Make |
sure you tighten the screw after remov- |
ing the thermostat sensing bulb. |
IMPORTANT: Do not force or bend the |
thermostat sensing bulb or capillary. |
3. The thermostat sensing bulb may be |
located to the lower right front side of |
fireplace. Determine location of sens- |
Thermostat
MountingSensing Bulb
Bracket
Figure 38 - Location of Gas Valve Assem- bly and Thermostat Sensing Bulb
Figure 39 -
Figure 42 - Locating Thermostat Sensing Bulb on
Thermostat
Sensing
Bulb
Adhesive- backed Mounting Clip
Glass Doors
Figure 43 - Installing Thermostat Sensing
ing bulb, but do not mount sensing bulb |
until step 5. If you have a masonry fire- |
place, see Figure 41 for location. If you |
have a |
Capillary
Thermostat Screw
Bulb behind Glass Doors
Figure 42 for location. If your fireplace |
has glass doors, position sensing bulb |
directly behind door gap on right bot- |
tom side (see Figure 43). |
Retaining Clamp
Capillary
Thermostat Sensing Bulb
Adhesive- backed Mounting Clip
Thermostat
Sensing Bulb
Figure 40 - Removing Thermostat Sens- ing Bulb
Do Not Crimp
Capillary
Figure 44 - Positioning the Thermostat Sensing Bulb in the Vertical Position with the Capillary at the Bottom
104385 | 23 |
