OWNER’S MANUAL

INSTALLATION

Continued

INSTALLING LOGS ON MODEL CCL3930NT(A)

WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.

CAUTION:Afterinstallationand periodically thereafter, check to en- sure that no flame comes in contact with any log. With the heater set to High, check to see if flames contact any log. If so, reposition logs ac- cording to the log installation in- structions in this manual. Flames contacting logs will create soot.

Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.

1.Place the front log (#1) on the grate fin- gers. Make sure the front log rest firmly between the grate fingers and the grate base (see Figure 23).

2.Place the base of the middle log (#2) in the U-shaped slots of the grate base. The cutout on the right of the middle log should fit over the burner (see Figure 24). Make sure the front of the middle log is resting on the tabs of the grate base.

3.Locate pegs on the bottom of back log (#3). Slide these pegs into the holes in the grate base behind the burner (see Figure 25).

Front Log (#1)

Grate

Fingers

Grate Base

Figure 23 - Installing Front Log (#1)

4.Locate pegs on the bottom of crossover log (#4). Slide these pegs into the holes located in middle log (#2) and back log (#3). See Figure 26 for placement.

5.Locate pegs on the bottom of crossover log (#5). Slide these pegs into the holes located in crossover log (#4) and front log (#1). See Figure 27.

Middle Log (#2)

Burner

Tab

U-Shaped

 

Slot

Figure 24 - Installing Middle Log (#2)

Pegs

Hole in

Grate Base

Burner

Figure 25 - Installing Back Log (#3)

Pegs

Log #2

Log #3

Figure 26 - Installing Crossover Log (#4)

6.Locate pegs on the bottom of crossover log (#6). Slide these pegs into the holes located in back log (#3) and front log (#1). See Figure 28.

7.Locate pegs on the bottom of crossover log (#7). Slide these pegs into the holes located in crossover log (#6) and front log (#1). See Figure 29.

8.Add lava rock around base of heater. Do not place any lava rock on logs or burner.

Crossover Log (#4)

Front Log (#1)

Figure 27 - Installing Crossover Log (#5)

Pegs

6

Log #2

Front Log (#1)

Figure 28 - Installing Crossover Log (#6)

Pegs

7

Crossover

Log (#6)

Front Log (#1)

Figure 29 - Installing Crossover Log (#7)

104385

15

Page 15
Image 15
Desa CLD3018N, CLD3924NT, CCL3930NT(A) Installing Logs on Model CCL3930NTA, Front Log #1 Grate Fingers Grate Base