CGS2718N, CGS3124N, CLD3018N,
CLD3924NT, and CCL3930NT(A)
UNVENTED NATURAL GAS LOG HEATER
INSTALLATION
Continued
INSTALLING LOGS ON MODELS CLD3018N AND CLD3924NT
WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property
1.Place the base of the middle log (#1) in the
2.Locate pegs on the bottom of back log (#2). Slide these pegs into the holes in the grate base behind the burner (see Figure 20).
3.Locate the notches in the bottom of the front log (#3). Place the front log on the grate fingers. Make sure the notches of the front log line up with the grate fingers (see Figure 21).
4.Place crossover log (#4) onto the pin (right) on back log (#2) and into the recess of the middle log (#1) (see Fig- ure 22).
5.Add lava rock around base of heater. Do not place any lava rock on logs or burner.
damage or personal injury.
CAUTION: After installation and periodically thereafter, check to ensure that no flame comes in contact with any log. With the heater set to High, check to see if flames contact any log. If so, re- position logs according to the log installation instructions in this manual. Flames contacting logs will create soot.
Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.
Middle Log (#1)
Tab
Burner
“U” Bend
Slot
Figure 19 - Installing Middle Log (#1)
Back Log (#2)
Hole in
Grate Base
Peg
Burner
Figure 20 - Installing Back Log (#2)
Notches
Front Log (#3)
Grate Fingers
Figure 21 - Installing Front Log (#3)
Crossover Log (#4)
Peg
Recess
Figure 22 - Installing Crossover Log (#4)
14 | 104385 |
