Installing the Wireless Switch

1Set the wireless switch into the base.

2Tighten the M2.5 x 5-mm screw. Slide the wireless On/Off switch to confirm that the board is connected to the base correctly. If the switch is too tight, then the alignment of the board to the base shifted during assembly. Loosen the M2.5 x 5-mm screw and confirm that the alignment of the bracket hole to the base hole is concentric.

3Install any Mini-Cards (see "Installing a Mini-Card" on page 173).

4Install the keyboard (see "Installing the Keyboard" on page 177).

5Install the display assembly (see "Installing the Display Assembly" on page 182).

6Install the hinge cover (see "Installing the Hinge Cover" on page 175).

Adding and Replacing Parts

197

Page 197
Image 197
Dell PP12S manual Installing the Wireless Switch, 197