2Align the card with the connector at a 45-degree angle, and press the card into the connector until it clicks.

NOTE: For more specific information about which cable to connect to which connector, see the documentation that came with your Mini-Card.

3Connect the cables to the Mini-Card, ensuring that you route the cables correctly.

4Replace the memory and Mini-Card cover, and tighten the two captive screws. See "Installing the Memory and Mini-Card Cover" on page 168.

Hinge Cover

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as a connector on the back of the Tablet-PC).

NOTICE: The hinge cover is fragile and can be damaged if extreme force is used. Be careful when removing the hinge cover.

Removing the Hinge Cover

1Follow the procedures in "Before You Begin" on page 155.

2Turn the Tablet-PC top-side up, and then open the display all the way (180 degrees) so that the display rests on your work surface.

NOTICE: To avoid damaging the hinge cover, do not lift the cover on both sides simultaneously. Removing the hinge cover in a different way than described may cause the plastic to break.

174

Adding and Replacing Parts

Page 174
Image 174
Dell PP12S manual Removing the Hinge Cover, 174