![](/images/new-backgrounds/1263640/263640389x1.webp)
1 | pen and whip antenna assembly | 2 | |
3 | M2 x | 4 | whip antenna cable |
5 | base |
|
|
Installing the Pen and Whip Antenna Assembly
1Seat the
2Tighten the two M2 x
3Install the system board (see "Installing the System Board" on page 191).
4Install the palm rest (see "Installing the Palm Rest" on page 189).
5Install the display assembly (see "Installing the Display Assembly" on page 182).
6Install any
7Install the keyboard (see "Installing the Keyboard" on page 177).
8Install the hinge cover (see "Installing the Hinge Cover" on page 175).
Wireless Switch
CAUTION: Before performing the following procedures, follow the safety instructions in your Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching a connector on the back panel of the
NOTICE: To avoid damaging the system board, you must remove the main battery before you begin working inside the
Removing the Wireless Switch
1Follow the procedures in "Before You Begin" on page 155.
2Remove the hinge cover (see "Removing the Hinge Cover" on page 174).
3Remove the display assembly (see "Removing the Display Assembly" on page 179).
Adding and Replacing Parts