1

M2 x 3-mm screws (4)

2

fan

3

fan cable connector

 

 

Installing the Fan

1Seat the fan into the system board, and tighten the four M2 x 3-mm screw using a #0 Phillips screwdriver.

2Connect the fan cable to the system board.

3Install the system board (see "Installing the System Board" on page 191).

4Install the palm rest (see "Installing the Palm Rest" on page 189).

5Install the keyboard (see "Installing the Keyboard" on page 177).

6Install the display assembly (see "Installing the Display Assembly" on page 182).

7Install the hinge cover (see "Installing the Hinge Cover" on page 175).

8Install any Mini-Cards (see "Installing a Mini-Card" on page 173).

Pen and Whip Antenna Assembly

CAUTION: Before performing the following procedures, follow the safety instructions in your Product Information Guide.

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching a connector on the back panel of the Tablet-PC.

NOTICE: To avoid damaging the system board, you must remove the main battery before you begin working inside the Tablet-PC.

Removing the Pen and Whip Antenna Assembly

1Follow the procedures in "Before You Begin" on page 155.

2Remove the hinge cover (see "Removing the Hinge Cover" on page 174).

3Remove the display assembly (see "Removing the Display Assembly" on page 179).

4Remove the keyboard (see "Removing the Keyboard" on page 176).

Adding and Replacing Parts

193

Page 193
Image 193
Dell PP12S manual Installing the Fan, Removing the Pen and Whip Antenna Assembly, 193