Installation, Continued, Installing Middle Log #2

INSTALLATION

Installing Logs (Cont.)

INSTALLATION

Continued

2.Place the base of the middle log (#2) in the U-shaped slots of the grate base in front of the back log. The cutout on the right of the middle log should fit over the burner (see Figure 20). Make sure the front of the middle log is resting on the tabs of the grate base and the cutout area is centered over the burner “U” bend.

3.Locate the recesses on the back of the front log (#3). Fit these recesses between the posts of the grate base (see Figure 21).

4.Locate the notches in the bottom of the crossover log (#4). Place the crossover log on top of the middle log and front log. Make sure the notches of the crossover log lines up with rectangular knobs on top of the middle and front logs (see Figure 22).

5.Place lava rock around base of heater if desired. Do not put lava rock on logs on burner.

Middle Log (#2)

Tab

Burner

Cutout

“U” Bend

U-Shaped Slot

Figure 20 - Installing Middle Log (#2)

Front Log (#3)

Recess

Post

Figure 21 - Installing Front Log (#3)

Notches	Crossover Log (#4)

Rectangular

Knobs

Figure 22 - Installing Crossover Log (#4)

Dual Burner Premium Aged Split Oak Models

WARNING: Failure to position the parts in accor- dance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.

Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.

1.Place the base of the middle log (#1) in the U-shaped slots of the grate base. The cutout on the right of the middle log should fit over the burner (see Figure 23). Make sure the front of the middle log is resting on the tabs of the grate base and the cut- out area is centered over the burner “U” bend.

Middle Log (#1)

Tab

Burner

“U” Bend

U-Shaped Slot