INSTALLATION
Installing Logs (Cont.)
15
INSTALLATION
Continued
2.Locate pins on the bottom of back log (#2). Slide these pins into the holes in the grate base behind the burner (see Figure 24).
3.Place crossover log (#3) onto the pin (right) on middle log (#1) and into the recess of the back log (#2). See Figure 25.
4.Locate the notches in the bottom of the front log (#4). Place the front log on the grate fingers. Make sure the notches of the front log line up with the grate fingers. See Figure 26.
Pin |
|
Hole in | Back Log (#2) |
| |
Grate Base |
|
Burner
5.With knot to right side, place smaller log piece (#5) over the pin on the left side of the middle log. The smaller log will rest on front log against the "knot" on the left. See Figure 27.
6.Place lava rock around base of heater if desired. Do not put lava rock on logs on burner.
Front Log (#4)
Notches
Grate Fingers
Figure 26 - Installing Front Log (#4)
Figure 24 - Installing Back Log (#2) | Log Piece (#5) |
Crossover Log (#3)
Recess | Pin |
| |
Pin |
|
Figure 27 - Installing Log Piece (#5)
Figure 25 - Installing Crossover Log (#3)
For more
visit www.
.com
