Operating Heater, Installing LOG SET | Desa CSBPT CSPBNT, CSPIPT

INSTALLATION

Continued

INSTALLING LOG SET

1.Set one-piece log on heater base as shown in Figure 12. Make sure middle section at bottom of log is seated into "U" shaped cutout in center of heater base. Log will fit securely on base. IMPORTANT: Make sure log does not cover any burner ports and does not touch the stove cavity (see Figure 14).

2.Fasten back panel to stove with four (4) bolts and washers re- moved in step 4 of Unpacking, page 6. Make sure product iden- tification label is located on the outside lower left-hand corner.

3.Place freestanding stove in desired position being careful not to damage gas connections. Be sure to maintain clearances to combustibles and wall clearances as outlined on page 7.

		One-Piece
		Log Set
		Middle Section
		at Bottom of
		Log Set
		Burner
		"U" Shaped
Heater		Cutout in
Heater	FFO	Chassis
Base

Figure 14 - Installing One-Piece Stove Log Set

Burner Porting Areas (double

One-Pieceslotted rectangular openings Log Set

Safety Pilot

Location

Figure 15 - Top View of One-Piece Log Set on Gas Log Heater

INSTALLATION	11
Installing Log Set	11
OPERATING HEATER
For Your Safety Read Before Lighting
Lighting Instructions

OPERATING HEATER

FOR YOUR SAFETY

READ BEFORE LIGHTING

WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing prop- erty damage, personal injury or loss of life.

A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.

B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

•Do not try to light any appliance.

•Do not touch any electric switch; do not use any phone in your building.

•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

•If you cannot reach your gas supplier, call the fire de- partment.

C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don’t try to repair it, call a qualified service techni- cian or gas supplier. Force or attempted repair may result in a fire or explosion.

D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

LIGHTING

INSTRUCTIONS

NOTICE: During initial operation of new heater, burning logs will give off a paper-burning smell. Orange flame will also be present. Open a window to vent smell. This will only last a few hours.

1.STOP! Read the safety information, abovc.

2.Make sure equipment shutoff valve is fully open.

3. Turn control knob clockwise Clockwise to the OFF position.

4.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Fol- low “B” in the safety information, above. If you don’t smell gas, go to the next step.

5. Turn control knob counterclockwise C-clockwiseto the PI-