® EVGL850N
VENTED TYPE DECORATIVE APPLIANCE
OPERATING
FIREPLACE
FOR YOUR SAFETY
READ BEFORE
LIGHTING
WARNING: If you do not fol- low these instructions exactly, a fire or explosion may result caus- ing property damage, personal injury or loss of life.
A.This appliance is equipped with an ignition device which automatically lights the pilot. Do not try to light the pilot by hand.
B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•Do not try to light any appliance.
•Do not touch any electric switch.
•Do not use any phone in your building.
•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
•If you cannot reach your gas sup- plier, call the fire department.
C.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been un- der water.
LIGHTING
INSTRUCTIONS
1.STOP! Read the safety information, column 1.
2.Turn off all electric power to the appliance.
3.Turn wall switch to the OFF position.
4.Remove the glass door.
5.Open control access panel.
6.Turn the equipment shutoff valve
clockwise Clockwise
to the OFF posi- tion (see Figure 27). Do not force.
7.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow “B” in the safety information, column 1. If you don’t smell gas, go to the next step.
8.Turn the equipment shutoff valve
counterclockwise 
C-clockwise
9.Close control access panel.
10.Replace the glass door.
11.Turn on all electric power to the ap- pliance.
12.Turn the wall switch to the ON posi- tion.
13.Visually locate the pilot. The ignitor should begin to spark and the main burner should ignite once flame ap- pears at pilot.
•If lighting the appliance for the first time each season, it may take several attempts before the supply gas can reach the pilot and main burners.
•If the appliance will not stay lit af- ter several attempts, follow the in- structions To Turn Off Gas To Ap- pliance, column 3, and call your service technician or gas supplier.
TO TURN OFF GAS
TO APPLIANCE
1.Turn off the wall switch.
2.Turn off all electric power to the ap- pliance if service is to be performed.
3.Remove the glass door.
4.Open control access panel.
5.Turn equipment shutoff valve clock- wise Clockwise
to “OFF”. Do not force.
6.Close control access panel.
7.Replace the glass door.
OPTIONAL REMOTE
OPERATION
Note: The WRC receiver and
1.Turn equipment shutoff valve to ON position. You can now turn the burner on and off with the
IMPORTANT: Be sure to press the ON/OFF buttons on the
2.Press the ON/OFF button to turn the burner on and off.
Pilot
AssemblyIgnitor/Sensor
Figure 28 - Pilot
Equipment Shutoff Valve
Control Valve
Figure 27 - Turning the Equipment Shutoff
Valve to the OFF position
12 | 107050 |
