![](/images/new-backgrounds/1199812/1998129x1.webp)
OWNER’S MANUAL
MANTEL CLEARANCES AND WALL DETAILS
A combustible mantel shelf maybe installed a maximum 9" (229mm) from the wall and musthaveaminimumdistanceof18" (457mm) above the fireplace opening. Figures 5 and 6 show the minimum allowable distances from various combustible mantle components in relation to the fireplace opening.
FRAMING
1. | Frame appliance enclosure as illus- |
| trated in Figures 7 and 8. |
| Note: If a wall covering is used to line |
| the enclosure, then all measurements |
| must be from the surface of the covering. |
2. | Place the appliance into the framing and |
| secure it. |
| Note: If appliance is to be raised above |
4. Feed flexible gas line through one of three |
gas line conduit sleeve and repack insu- |
lation to cover any openings. Prepare the |
incoming gas line with teflon tape or pipe |
joint compound and |
gas line to the flexible gas line. |
Note: If 1/2" NPT black iron pipe does |
not mate with fitting at the end of flex- |
ible gas line, remove fitting and replace |
with a 37 degree flare |
29.5°
9"
(229mm)
6"
(152mm)
12"
(305mm)
6" Min.
(152mm)
3" (76mm)
1 1/2"
(38mm) Max.
Combustible Materials
Header
Spacer
floor level, a platform must be built to |
support the appliance. |
3. Install the supply line to the appliance |
using a 1/2" NPT black iron gas line ter- |
minating 2 5/16" above the bottom of the |
appliance. The gas line may be installed |
from either side or from the rear of the |
appliance (see Figure 15, page 9). |
(female) fitting. |
WARNING: When finishing ap- pliance, Do not overlap combus- tible material onto the black front face. Brick, tile, or other noncom- bustible materials may be applied to the face provided that any gap is between the material used and the face is caulked with a non- combustible caulking.
Figure 5 - Mantel Clearances - Side View (Cross Section)
38 1/8"
(968mm) Min.
15"
(381mm)
1 1/2"
(38mm) Max.
3" (76mm) Max.
6" (152mm) Min.
TOP VIEW
Outer Surround
Combustible
Material May
Be Used
Safe
Zone
33°
Within 12" (305mm)
18" (457mm) Min.
15 5/8" Min. (397mm)
36 1/4"
(921mm) Min.
Figure 7 - Rough Opening for Installing in Wall
417/8"
(1061mm)
21 3/16"
(538mm)
29 5/8"
(752mm)
36 1/4"
(921mm)
59 1/4"
(1505mm)
CORNER INSTALLATION
Figure 8 - Rough Opening for Corner Installation
Figure 6 - Side Clearances - Top View (Cross Section)
107050 | 5 |