Desa installation manual Wall Switch Installation EVGL850N

® EVGL850N

VENTED TYPE DECORATIVE APPLIANCE

INSTALLATION

WALL SWITCH INSTALLATION (EVGL850N)

The installation of a wall switch allows you to activate the gas control valve and turn the fireplace on and off. The wall switch is to be connected to the incoming 120 volt regular household wiring that supplies the electric- ity to the fireplace. Refer to wiring diagram in this manual on page 14.

OPTIONAL REMOTE CONTROL INSTALLATION (Model WRC)

Note: If using optional wireless hand-held remote control, the wall switch must be in the ON position to be operational. The re- mote control then becomes the switching mechanism for fireplace operation.

1.The WRC model receiver does not re- quire a battery. The receiver can be in- stalled by first plugging the short ex- tension cord into the fireplace recep- tacle. Then plug the receiver unit into the extension cord. Finally plug the ig- nition module plug into the receiver unit (see Figure 12).

2.Activate the remote handset battery by removing the insulating tab on the back of the handset (see Figure 13). The bat- tery is included pre-installed.

3.Once the battery is activated the unit is ready to use.

Fireplace

Receptacle

Remote Control

Receiver

Extension Cord

Ignition Module Plug

Figure 12 - Installing the WRC Remote Receiver

Battery Cover

12 Volt Battery

Back of Handset

Pull to Remove

Insulation Tab

Figure 13 - Installing Battery into Back of Handset

8 107050