Desa installation manual Installing Blower Accessory Model FB32C only

Support bracket

12

INSTALLING

Continued

INSTALLING BLOWER ACCESSORY (Model FB32C only)

You may install blower accessory GA3500A with conventional installation (page

15)or with built-in installation (page 17) with model FB32C only. To install blower accessory, see instruction sheet included with the kit.

Conventional Installation of Blower Accessory

1. Install blower assembly per instruction sheet included in blower accessory kit.

2. Before replacing bottom of firebox, route blower power cord through hole in support bracket in bottom of firebox and through hole in side of firebox to grounded, three-prong 120 volt electrical outlet (see Figure 8). Plug electrical cord into outlet.

3. Replace bottom of firebox.

Blower	Electrical
	Outlet
	Side Opening
	Support Bracket Opening
	Blower Power Cord

Figure 8 - Routing Blower Accessory Power Cord for

Conventional Installation

NOTICE

A certified electrician must connect electrical wiring to duplex outlet for built-in installation. Follow all local codes.

Built-In Installation of Blower Accessory

1.Install blower assembly per instruction sheet included.

2.Before replacing bottom of firebox, remove screw holding duplex outlet to the support bracket in the bottom of firebox. Remove duplex outlet.

3.Clamp electrical cable into firebox through smallest hole using strain relief provided.

4.Route wires from electrical box through hole in side of heater and hole in support bracket (see Figure 9).

5.Connect wires from the electrical box to duplex outlet. Match wire colors to those indicated on duplex outlet. Be sure to connect ground wire.

6.Replace duplex outlet with screw.

7. Plug blower power cord into duplex outlet.

8. Replace bottom of firebox.

Cables From

Electrical

Source

Duplex Outlet

Blower

Screw

Blower Power Cord

Figure 9 - Routing Blower Accessory Power Cord for Built-In Installation

103296