INSTALLATION
Installing Heater To Wall 6,000 and 10,000 Btu/Hr Models (1.8 and 2.9 kW) (Cont.) Installing Heater To Wall 20,000 Btu/Hr Models (5.9 kW)
9
INSTALLATION
Continued
5.Tighten two screws until 1/16" (1.6 mm) space (thickness of penny) is between screwheads and wall (see Figure 9).
Thin or
Thick Wall
(thick wall shown)
1/16" Space (1.6 mm)
Solid
Wall
Figure 9 - Tightening Anchors
Placing Heater On Mounting Screws
1.Locate two keyhole slots on back panel of heater (see Figure 10).
2.Place large openings of slots over screwheads. Slide heater down until screws are in small portion of slots.
Installing Bottom Mounting Screw
1.Locate bottom mounting hole. This hole is near bottom on back panel of heater (see Figure 12).
2.Mark screw location on wall.
3.Remove heater from wall.
4.If installing bottom mounting screw into hollow or solid wall, install wall anchor. Follow steps 1 through 5 under Attaching To Wall Anchor Method, page 10. If installing bottom mounting screw into wall stud, drill hole at marked location using 9/64" drill bit.
5.Replace heater on wall.
6.Insert bottom anchor screw through back panel into bottom anchor or drilled hole (see Figure 12).
7.Tighten screw until heater is firmly secured to wall. Do not over tighten.
Note: Do not replace front panel at this time. Replace front panel after making gas connections and checking for leaks (see pages 11 and 12).
Keyhole Slots
Figure 10 - Location Of Keyhole Slots On Back Panel Of Heater
Removing Front Panel Of Heater
1.Remove two screws near bottom corners of front panel.
2.Lift straight up on grill guard until it stops. Grill guard will slide up about 1/4" (6 mm).
3.Pull bottom of front panel forward, then down.
Figure 12 - Installing Bottom Mounting Screw
INSTALLING HEATER TO WALL 20,000 BTU/HR MODELS (5.9 KW)
Mounting Bracket
Locate mounting bracket in heater carton. Remove mounting bracket from heater carton.
Figure 13 - Mounting Bracket
Figure 11 - Removing Front Panel Of Heater
For more information, visit www.desatech.com
