FIREPLACE
INSTALLATION
Continued
OPTIONAL GLASS DOOR
Glass doors are optional with this gas appliance (see Replacement Parts and Accessories, page 19).
Installing Glass Door
1.Be sure top spring clip hole is aligned with hole in fireplace frame (see Figure 21). Fit glass door top pin into aligned holes.
2.Swing inner end of bottom clip out away from fireplace frame. Fit door bottom pin into clip. Push clip into frame until bottom door pin slips into hole in frame.
3.Check door alignment. If doors do not align with each other, use top spring clip to align.
a.Use Phillips screwdriver to loosen screw that holds top spring clip in place.
b.Push spring clip left or right in its align- ment slot until door is at proper angle (aligned with opposing door). Moving spring clip to the LEFT (your left as you face the fireplace) moves glass doorʼs top, inner corner UP; moving spring clip to the RIGHT moves glass doorʼs top, inner corner DOWN.
c.When door alignment is satisfactory, use Phillips screwdriver to retighten spring clip screw.
WARNING: When fireplace is in operation, both sets of cabinet doors on each side of the fireplace must be either FULLY OPEN or FULLY CLOSED. If not, a fire hazard may be created.
Only doors certified with this appliance may be used. When operating doors, do not slam or abuse them. Always keep area below bottom edge of doors clear of obstacles or debris. Do not operate this appliance if glass doors are broken or dam- aged. See Figure 22.
Top Slot
Under Frame
Adjustment
Clip
Adjustment
Screw
Long Pivot Pin
Bottom Pin
Bottom Slot
Adjustment Clip
Figure 21 - Installing Glass Doors
Glass Doors Must be Fully Open (as Shown) or Fully Closed when Appliance is in Operation
Figure 22 - Glass Doors Shown Fully
Open
12 | www.desatech.com |
