Installation
Continued
INSTALLING HEATER TO WALL
Mounting Bracket
Locate mounting bracket in heater carton. Re- move mounting bracket from heater carton.
Figure 6 - Mounting Bracket
Removing Front Panel Of Heater
1.Remove the four painted screws, two on each side of front panel.
2.Pull bottom of front panel forward, then out.
3.Remove any remaining packaging materials.
Front Panel
Screw
Figure 7 - Removing Front Panel Of
Heater
Methods For Attaching Mounting Bracket
To Wall
Only use last hole on each end of mounting bracket to attach bracket to wall. These two holes are 14" (35.6 cm) apart from their cen- ters. Attach mounting bracket to wall in one of two ways:
1.Attaching to wall stud
2.Attaching to wall anchor
Attaching to Wall Stud: This method pro- vides the strongest hold. Insert mounting screws through mounting bracket and into wall studs.
Attaching to Wall Anchor: This method al- lows you to attach mounting bracket to hollow walls (wall areas between studs) or to solid walls (concrete or masonry).
Decide which method better suits your needs. Either method will provide a secure hold for the mounting bracket.
Marking Screw Locations
1.Tape mounting bracket to wall where heater will be located. Make sure mount- ing bracket is level.
WARNING:Maintainminimum clearances shown in Figure 8. If youcan,providegreaterclearanc- es from floor and joining wall.
2.Mark screw locations on wall (see Figure 8).
Note: Only mark last hole on each end of mounting bracket. Insert mounting screws through these holes only.
3.Remove tape and mounting bracket from wall.
| 12" | 14" (35.6 cm) |
|
| (30.4 |
|
|
| cm) |
|
|
AdjoiningWall | Min. |
|
|
Only Insert Mounting | 18 3/4" | ||
Screws Through Last | (47.6 cm) | ||
|
| Hole On Each End | Min. |
|
|
| |
Floor
3 Plaque Heater
16" | 14" (35.6 cm) |
(40.6 cm) |
|
Min. |
|
AdjoiningWall | Only Insert Mounting | 18 3/4" |
Screws Through Last | (47.6 cm) | |
| Hole On Each End | Min. |
Floor
5 Plaque Heater
Figure 8 - Mounting Bracket Clearances
Attaching Mounting Bracket To Wall Note: Wall anchors, mounting screws and spacers are in hardware package. The hard- ware package is provided with heater.
Attaching To Wall Stud Method
For attaching mounting bracket to wall studs
1. Drill holes at marked locations using 9/64" drill bit.
2. Place mounting bracket onto wall. Line up last hole on each end of bracket with holes drilled in wall.
3. Insert mounting screws through bracket and into wall studs.
4. Tighten screws until mounting bracket is firmly fastened to wall studs.
www.desatech.com |
