INSTALLATION
Installing Logs
15
INSTALLATION
Continued
INSTALLING LOGS
WARNING: Failure to position the parts in accor- dance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.
CAUTION: After installation and periodically there- after, check to ensure that no yellow flame comes in contact with any log. With the heater set to High, check to see if flames contact any log. If so, reposi- tion logs according to the log installation instruc- tions in this manual. Yellow flames contacting logs will create soot.
It is very important to install the logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.
Models CGX3924NT, CGX3924PT, CGX3930NT, CGX3930PT, CGX3924NR, AND CGX3924PR
1.Place log #1 (ember bed) onto the base. Position the log over the shoulder bolts on either side of the front burner. The log will sit on top of the front burner (see Figure 19).
2.Place log #2 behind the back burner and onto the three tabs as shown in Figure 20.
3.Place log #3 on the left side of the base. It will overlap log #1 and log #2 and will wrap around the front end of the back burner (see Figure 21).
4.Place log #4 onto the pins on the right side of log #1 and onto the “ledge” on the front of log #2 (see Figure 22).
5.Place log #5 over the knob on log #2 and across the back part of log #1. It will slant down toward the front (see Figure 22).
Figure 20 - Installing Log #2 (Model CGX3930NT Shown)
Figure 21 - Installing Log #3 (Model CGX3930NT Shown)
Figure 19 - Installing Log #1 [Ember Bed] (Model CGX3930NT
Shown)
Figure 22 - Installing Logs #4 and #5 (Model CGX3930NT
Shown)
For..com
108114