Local Codes

PRODUCT IDENTIFICATION

OPTIONAL REMOTE CONTROL ACCESSORIES LOCAL CODES

UNPACKING

PRODUCT IDENTIFICATION

Log Set (Varies

According to Model)

Grate

Piezo
Ignitor Control
Knob	Rear Burner	Base
		Base
		Assembly
	Control Knob	Assembly
	Control Knob

Thermostat Models: VGX24NT, VGX24PT, VGX30NT, VGX30PT,

CGX3924NT, CGX3924PT, CGX3930NT, CGX3930PT

	Grate	Base Extension
Selector	Grate
Selector			Pilot
Switch			Pilot
Switch			Assembly Rear
(Optional)			Assembly Rear
(Optional)			Burner
			Burner
Flame
Adjustment
Knob	Piezo	Front Burner
Control Ignitor		Front Burner	Base
Knob			Base
Knob			Extension (30"
			Extension (30"
			Models Only)
Remote Control		Rear Burner	Base
(Optional)			Base
(Optional)
		Control Knob Assembly

Remote-Ready Models: VGX24NR, VGX24PR, VGX30NR, VGX30PR, CGX3924NR, CGX3924PR, EX24NR, EX24PR, EX30NR and EX30PR

OPTIONAL REMOTE CONTROL ACCESSORIES

There are four optional remote controls that can be purchased separately for Remote-Ready Models Only:

•	wall switch	•	hand-held ON/OFF remote
•	wall thermostat	•	hand-held thermostat remote.

See Accessories, page 38.

The wall thermostat or hand-held thermostat may not be used where vented decorative listing is required.

Install and use heater with care. Follow all local codes. In the absence of local codes, use the latest edition of The National Fuel Gas Code ANSI Z223.1/NFPA 54*.

*Available from:

American National Standards Institute, Inc.

1430 Broadway

New York, NY 10018

National Fire Protection Association, Inc.

Batterymarch Park

Quincy, MA 02269

Note: Where listed vented decorative logs are required, thermostat operation is not permitted.

UNPACKING

CAUTION: Do not remove the metal data plates from the base assembly. The data plates contain important warranty and safety information.

1.Remove logs and heater base assembly from carton. Note: Do not pick up heater base assembly by burners. This could damage heater. Always handle base assembly by the sides of assembly.