LFP33PR
UNVENTED PROPANE/LP GAS FIREPLACE
INSTALLATION
Continued
OPTIONAL WIRELESS HAND- HELD REMOTE CONTROL ACCESSORY RM4
Installing Remote Receiver Unit
1.Disconnect switch wires from the con- trol valve.
2.Remove screws and nuts attaching switchplate. Save screws and nuts to attach receiver.
3.Remove switch plate (see Figure 27). Discard after removing.
4.Install remote receiver unit onto remote switch bracket using screws and nuts removed in step 2. See Figure 28
5.Route wires through hole in the upper portion of the switch plate (Figure 28). Connect wires as shown in Figure 29. (Black and blue wires are not used for this application.)
Remote Switch | Ignitor |
Bracket |
|
Screw
White Wire
From Receiver
Valve
Red Wire From
Receiver
Figure 29 - Connecting Wires
INSTALLING BATTERIES FOR RM4
Four AA and two AAA batteries (not in- cluded) are required to operate this heater with the wireless hand held remote control set. AA batteries must be installed in the receiver and AAA batteries in the
Installing Batteries in Receiver
1.Locate back of receiver behind the re- mote switch bracket under the firebox bottom.
2.Slide the battery door off of the receiver in the direction of the arrow on the door.
3.Insert the four AA batteries according to Figure 30.
4.Slide the battery door back into position.
Installing Batteries in
1.Remove battery cover on front of re- mote control unit following direction of arrow.
2.Insert two AAA batteries following dia- gram in battery housing area.
3.Replace battery cover onto remote con- trol unit.
Remote
AAAControl Unit
Batteries
-
+
Battery - +
Cover
Battery
Housing
Figure 31 - Installing Battery in Hand- Held Remote Control Unit
Switch Plate | Wires |
Figure 27 - Switch Plate and Wiring Harness
Screws | Terminal |
| Wires |
+
-+
+ - -
+
Nuts
Remote Receiver
Remote | AA Batteries | |
Receiver | ||
| ||
Battery Door |
|
Figure 30 - Installing Battery in Remote Receiver
Figure 28 - Installing Remote Receiver
14 | 104888 |