TROUBLESHOOTING
WARNING: Turn off appliance and let cool before servicing. Only a qualified service person should service and repair heater.
CAUTION: Never use a wire, needle or similar object to clean ODS/pilot. This can damage ODS pilot unit.
Note: All troubleshooting items are listed in order of operation.
OBSERVED PROBLEM | POSSIBLE CAUSE | REMEDY | ||
|
|
|
| |
When ignitor button is pressed, | 1. Ignitor electrode not con- | 1. | Reconnect ignitor cable | |
there is no spark at ODS/pilot |
| nected to ignitor cable |
|
|
| 2. | Ignitor cable pinched or | 2. | Free ignitor cable if pinched |
|
| wet |
| by any metal or tubing. Keep |
|
|
|
| ignitor dry |
| 3. | Broken ignitor cable | 3. | Replace ignitor cable |
| 4. | Bad piezo ignitor | 4. | Replace piezo ignitor |
| 5. | Ignitor electrode positioned | 5. | Replace pilot assembly for |
|
| wrong or broken |
| |
When ignitor button is pressed in there is spark at ODS/pilot but no ignition
1.Gas supply turned off or equipment shutoff valve closed
2.Control knob not in PILOT position
3.Control knob not pressed in while in PILOT position
4.Air in gas lines when in- stalled
5.Depleted gas supply (pro- pane/LP only)
6.ODS/pilot is clogged
7.External gas regulator setting is incorrect
1.Turn on gas supply or open equipment shutoff valve
2.Turn control knob to PILOT position
3.Press in control knob while in PILOT position
4.Continue holding down con- trol knob. Repeat igniting op- eration until air is removed
5.Contact local propane/LP gas company
6.Clean ODS/pilot (see Cleaning and Maintenance, page 12) or replace ODS/pilot assembly
7.Replace gas regulator
www.desatech.com | 13 |
