12
INSTALLATION
Ember and Pan Material Placement
Log Placement for P324E/VP324E Models
INSTALLATION
Continued
EMBER AND PAN MATERIAL PLACEMENT
1.Open the bag(s) of vermiculite and fill the entire burner pan until the burner tube is completely covered (see Figure 19).
2.Smooth the pan material just even with edges of the burner pan.
3.Remove the ember material from the bag and flatten small amounts into quarter size pieces and lay on top of the surface of the pan material (see Figure 20).
4.Place just enough to cover the entire surface and leave about a 1/2 inch gap under the lower grate members to allow air to flow (see Figure 21).
Grate | Vermiculite | Burner Pan |
(Pan Material) |
| |
|
|
Figure 19 - Fill Entire Burner Pan with Vermiculite (P325E/ VP325E Model Shown)
| Ember | Vermiculite |
| |
Grate | Material | Burner Pan | ||
(Pan Material) | ||||
|
|
|
Figure 20 - Ember Material on Surface of Pan Material (Vermiculite) (P325E/VP325E Model Shown)
Pan and Ember
Grate Material
0.5"
0.5"
Burner Pan
Figure 21 - Pan and Ember Material Clearances (P325E/VP325E Model Shown)
LOG PLACEMENT FOR P324E/VP324E MODELS
1.Place front (log 1) onto front of grate sliding log all the way forward against grate fingers (see Figure 22).
2.Insert pegs on bottom of rear log (log 2) into holes in rear of grate (see Figure 22).
3.Insert pegs on back of log 3 into right hole on log 1 and right hole of log 2 (see Figure 23).
4.Insert pegs on back of log 4 into left hole on log 1 and left hole of log 2 (see Figure 23).
To enhance the look of the hearth you may optionally place the lava rock provided around the front and sides of the burner.
NOTICE: Do not put lava rock inside the burner pan or around the air mixer fitting. Placing lava rock inside the burner pan or blocking the openings of the propane/LP
Log 1
Log 2
Figure 22 - Installing Logs 1 and 2
Log 4
Log 3
Figure 23 - Installing Logs 3 and 4
For more
visit www.
.com
108794
