Alliance Laundry Systems PHM798N Delivery Inspection, Name plate Location, Replacement Parts

This manual is designed as a guide to the installation of the Pocket Hardmount washer-extractor.

NOTE: All information, illustrations, and specifications contained in this manual are based on the latest product information available at the time of printing. We reserve the right to make changes at any time without notice.

IMPORTANT: Warranty is void unless washer- extractor is installed according to instructions in this manual. Installation should comply with minimum specifications and requirements, and with applicable municipal building codes, water supply regulations, electrical wiring regulations and any other relevant statuary regulations. Due to varied requirements, applicable local codes should be thoroughly understood and all pre-installation work arranged for accordingly.

Delivery Inspection

Upon delivery, visually inspect crate, protective cover, and unit for any visible shipping damage. If the crate, protective cover, or unit is damaged or signs of possible damage are evident, have the carrier note the condition on the shipping papers before the shipping receipt is signed, or advise the carrier of the condition as soon as it is discovered.

Remove the crate and protective cover as soon after delivery as possible. If any damage is discovered upon removal of the crate and/or protective cover, advise the carrier and file a written claim immediately.

Name plate Location

The nameplate is located on the back of the machine. Always provide the machine’s serial number and model number when ordering parts or when seeking technical assistance. Refer to Figure 1 and Figure 2.

Nameplate Location - UniLinc Models

On UniLinc models, nameplate information is also programmed into the control. To access machine ID through the control:

1.Press and hold , then , then keypads at the same time.

2.Press the keypad until Diagnostic is highlighted.

3.Press the keypad.

4.Press the keypad until machine ID is highlighted.

Introduction

5. Press the keypad.

Always provide the machine’s serial number and model number when ordering parts or when seeking technical assistance. Refer to Figure 1.

MODEL EXAMPLE OF NAMEPLATE LOCATION

1 2

PHM798N

1In Control (UniLinc Models)

2At Back of Machine

Figure 1

Replacement Parts

If literature or replacement parts are required, contact the source from which the washer-extractor was purchased or contact Alliance Laundry Systems LLC at (920) 748-3950 for the name of the nearest authorized parts distributor. A parts manual may be ordered by returning the reply card provided with each washer-extractor.

Customer Service

For technical assistance, contact your local distributor or call:

(920)748-3121 Ripon, Wisconsin

A record of each washer-extractor is on file with the manufacturer. Always provide the machine’s serial number and model number when ordering parts or when seeking technical assistance. Refer to Figure 1 and Figure 2.

F8138601 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 9