OWNER’S MANUAL
PRODUCT
IDENTIFICATION
Hot Air | Thermostat Knob |
Outlet | |
| Upper Shell |
Lower
Shell
Fuel 
Cap
Side Cover
Ignition Control Assembly (assembly on inside of side cover)
Figure 1 - Portable Forced Air Heater
Fan Guard
Fuel Tank
Power Cord
ASSEMBLY
These models are furnished with wheels and a front handle. Some models are furnished with a rear handle also. Wheels, handle(s), and the mounting hardware are found in the shipping carton.
TOOLS NEEDED
•Medium Phillips Screwdriver
•3/8" Open or Adjustable Wrench
•Hammer
1. | Slide axle through wheel support frame. |
| Install wheels on axle. |
| IMPORTANT: When installing wheels, |
| point extended hub of wheels toward |
| wheel support frame (see Figure 2). |
2. | Place cap nuts on axle ends. Gently tap |
| with hammer to secure. |
3. | Place heater on wheel support frame. |
| Make sure air inlet end (rear) of heater is |
| over wheels. Line up holes on fuel tank |
| flange with holes on wheel support frame. |
4. | Place front handle (and rear handle if pro- |
| vided) on top of fuel tank flange. Insert |
| screws through handle(s), fuel tank flange, |
| and wheel support frame. Attach nut |
| finger tight after each screw is inserted. |
5. | After all screws are inserted, tighten |
Screw
Hot Air
Outlet
Fuel
Tank
Flange
Wheel
Support
Frame
WheelNut
Cap Nut
Front
Handle
Rear
Handle
Air Inlet
Extended Hub
Axle
nuts firmly. |
Figure 2 - Wheel and Handle Assembly
104193 | 3 |
