OWNER’S MANUAL
FREESTANDING FIREPLACE ASSEMBLY
Continued
INSTALLING OPTIONAL BLOWER ACCESSORY
NOTICE: If installing blower in an existing fireplace with gas con- nections, shut off gas supply and disconnect heater from gas sup- ply. Contact a qualified service person to do this.
Attaching Thermal Switch to DA3610T Thermostatically Controlled Blower
When installing the DA3610T thermostati- cally controlled blower accessory, you must first secure the thermal switch to the blower.
1. | Remove the two hex head screws on the |
| blower assembly as shown in Figure 15. |
2. | Place the green wire between the bot- |
| tom hole on the thermal switch bracket |
| and the bottom hole on the blower as- |
| sembly. Insert one of the hex screws |
| into all three pieces and tighten. |
3. | Insert the top screw through the ther- |
| mal switch bracket and into the blower |
| assembly. Tighten screw. |
4. | Connect the blue wire on the blower |
| assembly to the right side of the ther- |
Installing GA3700/DA3610T Blowers
1.Align the holes in the top mounting tabs of blower with holes in wall of rear cover (see Figure 16). Using the 4 screws provided, mount blower and tighten screws securely.
Note: For DA3610T, make sure the ther- mal switch has been properly installed to fit against the back of the firebox.
2.Make sure all wire connections to ter- minals on blower motor (and thermal switch where applicable) are securely attached and that the screw retaining the green ground wire is tight.
3.Place speed control on left inside of rear cover and push the plastic control shaft through opening (see Figure 16).
4.While supporting speed control, secure control shaft with lock nut by pushing and turning lock nut with pliers clockwise until tight against the side of rear cover. Place control knob provided onto shaft (see Figure 16).
5.Plug in blower power cord.
6.Check to make sure that the power cord is completely clear of the blower wheel and that there are no other foreign ob- jects in blower wheel. Turn blower on and check for operation. Turn blower off by rotating knob fully counterclock- wise before continuing.
WARNING: Never touch the blower wheel while in operation.
7.Peel off the backing paper and stick the supplied wiring diagram decal on the inside of rear cover on right side oppo- site control.
WARNING: Failure to position the parts in accordance with sup- plied diagrams or failure to use only parts specifically approved with this heater may result in dam- age or personal injury.
8.Connect or reconnect gas supply to fire- place per Connecting Fireplace to Gas Supply on page 13 of this manual.
WARNING: A qualified ser- vice person must connect fire- place to gas supply. Follow all local codes.
mal switch. |
5. Connect the black wire to the left side |
of the thermal switch. |
Black | White Wire | |
Wire | ||
Blower | ||
| ||
| Assembly | |
Thermal | Green | |
Switch | ||
Wire | ||
with | ||
Blue Wire | ||
Bracket | ||
Hex Head | ||
| ||
| Screws |
Figure 15 - Attaching Thermal Switch to DA3610T Thermostatically Controlled Blower Accessory
Blower | Control |
Control Knob | Shaft |
Lock | Speed Control |
| |
Nut | Power Cord |
Mounting Screws (Included in Hardware Pack)
White | Black |
| |
Wire | Wiring | ||
Wire | |||
| Diagram | ||
|
| ||
|
| Decal |
Blue | Green |
| Rear Cover |
Wire | Blower | ||
| Ground Wire |
|
|
Figure 16 - Installing Optional Blower Accessory (Thermostat Model DA3610T Shown)
Continued
105500 | 7 |