Desa (V)T32P-A SERIES, (V)T32N-A SERIES Fireplace Installation, Continued, Removing Louver Panels

FIREPLACE INSTALLATION

Installing Optional Wireless Hand-Held Remote Control - HRC100 and HRC200 Series Removing/Replacing Glass Door

21

FIREPLACE INSTALLATION

Continued

INSTALLING OPTIONAL WIRELESS HAND- HELD REMOTE CONTROL - HRC100 AND HRC200 SERIES

NOTICE: Use only alkaline batteries (not included).

Installing Remote Receiver

1.Open bottom louver and locate the switch bracket on the left.

2.Unscrew the switch bracket. Lean bracket forward so you are able to access the back of the remote receiver.

3.Locate the battery clip mounted on the back of the receiver. Slide a 9-volt alkaline battery (not included) through the clip (see Figure 37).

4.Attach the terminal wires to the battery.

5.Connect wires from receiver to TH and TPTH to control valve (see Figure 38).

6.Replace the switch bracket.

Battery	Remote Control Unit
Cover

Terminal

Wires

Battery

Housing

9-Volt Battery

Figure 39 - Installing Battery in Hand-Held Remote Control Unit REMOVING/REPLACING GLASS DOOR

CAUTION: Do not operate this fireplace with a broken glass door panel or without the glass door panel securely in place. For replacement part infor- mation see Replacement Parts, page 34.

Receiver

9-Volt Alkaline

Battery

Terminal Wires

Battery Clip

Figure 37 - Attaching Alkaline Battery to Receiver

To Optional

Remote

Accessory

CAUTION: Wear gloves and safety glasses while handling or removing broken glass. Do not remove if glass is hot. Keep children and pets away from glass.

WARNING: If fireplace has been running, turn off and unplug fireplace. Let cool before removing glass door or louvers.

Removing Louver Panels

Remove the top and bottom louver panels by simultaneously pulling both top end spring latches towards the center of the appliance until they are disengaged from the locating holes (see Figure 40). Repeat for bottom spring latches and pull the louvers outward. To install or replace items removed, simply reverse the procedures above.

Figure 38 - Control Valve Terminals

Installing 9-Volt Alkaline Battery in Hand-Held		Louver Panel
Remote Control Unit
1.	Remove battery cover on back of remote control unit.		Spring Latch
2.	Attach terminal wires to the battery. Place battery into the bat-
		Figure 40	- Removing Louver Panel
	tery housing.

3.Replace battery cover onto remote control unit.

116646-01B www.desatech.com