Safety Information, Product Identification | Desa Td101, Td103, Td109, Td111

SAFETY INFORMATION

Continued

16.Never move, handle, or service a hot or operating heater. Severe burns may result. You must wait 20 minutes after turning heater off.

17.To prevent injury, wear gloves when han- dling heater.

18.Turn off heater valve and gas supply to heater when not in use.

19.Use only original replacement parts. This heater must use design-specific parts.

Do not substitute or use generic parts. Improper replacement parts could cause serious or fatal injuries.

20.Certain materials or items, when stored in front of heater, will be subjected to radiant heat and could be seriously damaged.

21.Shut heater off immediately if fashback occurs (fame inside burner tube). Have heater serviced.

22.Never attempt to use heater or any components that have been damaged or exposed to accidental fire.

23.If you smell gas or suspect a leak, shut off propane/LP cylinder valve at once. Ventilate area. Do not strike a match or create any fame or electric spark. Find and correct leak before attempting to light any appliance.

24.Do not block intake air openings.

25.Use correct pressure specifications, see page 11.

26.Propane/LP gas cylinder is not provided. Use a 20 lb. propane/LP gas cylinder marked propane. The cylinder supply sys- tem must be arranged for vapor withdrawal. The cylinder used must include a collar to protect the cylinder valve. The cylinder must be provided with a shutoff valve terminating in a propane/LP gas supply cylinder valve outlet specified, as applicable, for connec- tion no. 510 in the Standard for Compressed Gas Cylinders Valve Outlet and Inlet Con- nections, ANSI/CGA-V-1, or connection no. 600 in the Compressed Gas Association’s

Limited Standard Cylinder Valve Outlet Connection for Propane Small Valve Series or combination propane/LP gas cylinder valve and quick-disconnect assembly complying with 1.16.5-c and a safety relief device having a direct communication with the vapor space of the cylinder.

Product

Identification

	Table
	Top
	Guard
	Rail
	Emitter
	Decorative
	Grate
Control
Knob	Ignitor

Figure 2 - Infrared Patio Table Heater

Unpacking

1.Remove all packing items applied to heater for shipment.

2.Remove all items from carton.

3.Check all items for shipping damage. If heater is damaged, promptly inform dealer where you bought heater.

Assembly

Estimated assembly time: 55 minutes Tools required:

•#2 Phillips screwdriver

•8 mm and 10 mm Open end wrench Hardware packet provided with heater may contain more parts than needed for heater assembly. Parts are referenced by designated letter throughout assembly instructions. Hard- ware packet contains the following (quantity used in parenthesis):

	Description	Part Number
A	1" Screw (6)	119619-04
B	5 mm Washer (6)	119600-02
C	3/8" Screw (59)	119620-02
D	1 1/2" Screw (6)	119619-05
E	5 mm Hex Nut (6)	NPC-3C
F	3/8" Machine Screw (6)	119742-01
G	M6 Hex Nut (6)	119743-01