Assembly
Continued
5.Remove wire tie and packing material from regulator located underneath burner support plate.
6.Position burner support plate on top of panels while carefully inserting control valve through hole in control panel.
7.Attach control valve bracket to table control panel with 2 screws (C). Attach control knob to control valve from outside of heater. See Figure 5.
8.Attach burner support plate to panels with 4 screws (C) (see Figure 5).
9.Attach emitter screens to emitter brackets with 4 screws (C) as shown in the Figure 5.
10.Attach emitter cap to emitter brackets with 2 screws (C) as shown in Figure 5.
11.Attach emitter assembly to burner support plate with 2 screws (C) (see Figure 5).
12.Model TD109 only: Place 3 screens around
| Emitter Cap | |
| Emitter | |
| Screen | |
| Emitter | |
| Bracket | |
Burner | Control Valve | |
Underneath | ||
Support | ||
Burner | ||
Plate | ||
Support Plate | ||
|
grate pillars. For all models, place 3 table decorative grate pieces around grate pil- lars. Attach to grate pillars with 4 screws
(C) per grate as shown in Figure 6.
13. Attach grate assembly to burner support plate using 3 screws, (C) one through bottom of each deco grate pillar (see
Figure 7). | Table Decorative |
| |
Deco | Grate (Models |
Grate | TD101, TD103 |
Pillar | and TD111 |
| shown) |
Screen (Model TD109 only)
(Holes 
closest to edge should be on the bottom)
Figure 6 - Deco Grate and Grate Pillar
Assembly
Hole for Control Valve
Control
Knob
Screw through Deco Grate Pillar
Burner
Support
Plate
Ring
Retainer
Figure 5 - Assembling Emitter and
Attaching Burner Support Plate
Figure 7 - Attaching Grate Assembly to
Heater
www.desatech.com118992-01F
